Rohnson R-8068 User manual

PTC Ceramic Fan Heater
MODEL: R-8068
220-240V~ 50Hz 1800W
INSTRUCTION MANUAL
This product is only suitable for well insulated spaces or occasional use

USER INSTRUCTIONS
IMPORTANT SAFEGUARDS
PLEASE READ CAREFULLY – ALWAYS MAINTAIN SAFETY
WHEN WORKING WITH ANY APPLIANCE
·Check that the mains voltage corresponds with the rating of the appliances
in water or any other liquid.
·Do not touch hot surfaces – Use handles or knobs
·To protect against electric shock, do not immerse cords, plugs or
appliances in water or any other liquid.
·Do not leave any appliance unattended while it is operation.
·Close supervision is necessary when any appliance is used by or near
children or infirm person.
·Unplug from outlet when not in use or before cleaning. Allow to cool
before putting on or taking off any parts.
·Do not operate the appliance with a damaged cord or plug. or after the
appliance has been damaged in any manner. If the supply cord or appliance
if damaged, it must be replaced by the manufacturer or it’s service agent or
a similarly qualified person in order to avoid a hazard.
·The use of accessory attachments not recommended
·The use of accessory attachment not recommended by the appliance
manufacturer may cause injuries,
·Do not use outdoors.
·Do not let the cord hang over the edge of a table or counter or let it come
into contact with any hot surfaces.
·To disconnect-remove the plug from the outlet. Do not pull plug out by
the cord.
·No liability can be accepted for any damage caused by noncompliance
with these instructions or any other improper use or mishandling.
·Never use the appliance near a bath, shower or a swimming pool.
·Never place flammable objects or clothing on top of the heater.
·Allow a 50cm safe area around the heater on the top and sides and a 120cm
safe area at the front.
·Never use a heater in a room with explosive gas such as petrol. or while
using and kinds of flammable glues. sprays or solvents.
·Prevent overheating of the appliance by keeping the air inlets and outlets
clean and free of anything that may cause blockage. Check all inlets and
outlets from time to time for accumulated dust. DO NOT COVER.
·If overheating should occur, the built-in overheating safety device will
shut the appliance off.
·Do not insert any foreign objects into the grill.
·Keep the rear grill clear of any draped fabric or curtains.

OPERATION OF YOUR HEATER
·Remove the heater from all packaging and place it in desired location.
·Ensure that there is a safe area between the heater and furniture, curtains,
etc-50cm safe area form top and sides and 120cm safe area in front.
·Unwind the Power Cord and plug it into the Power Outlet.
·To activate the heater, turn the knob clock-wise to the ‘ ’position for
cool air. Turn knob to ‘I’ for 900W, ’II’ for1800W.
·Use the switch on the back side of the heater to turn oscillation ON or
OFF.
Thermostat Switch
Pilot lamp
Oscillation Switch
AUTO SAFETY SHUT OFF
The heater has a built-in safety device, which will switch the heater OFF
in case of accidental overheating. To reset the heater, follow the next steps:
·Turn the control setting to the ‘O’ position.
·Unplug the heater and wait 5-10minutes for the unit to cool down.
·After the unit has cooled, plug it in and operate normally.
·Turn rotary switch into desired position (Fan, Low or High).
·Turn the thermostat switch to the desired temperature position.
·When you feel the room temperature comfortable, turn the thermostat
switch anti-clockwise slowly to the minimal direction until the appliance
switches off.
·The thermostat switch will keep the room temperature at the desired
temperature automatically.
·You can also turn the thermostat switch anti-clockwise to the minimum
position or turn the thermostat switch clockwise to the maximum position
to make the temperature lower or higher.
ANTI-TILT SWITCH PROTECTOR:
This heater is equipped with a safety tip-over switch which automatically
shuts off the heater element if the heater is not in the upright position, the
heater will resume back to normal when the heater is returned to the upright
position.

Note: NEVER COVER THE HEATER
CLEANING AND MAINTENANCE
·Be sure to switch off power supply and pull out the plug before cleaning.
·Wait for the heater to cool down sufficiently.
·Clean the body of the heater with a damp cloth. DO NOT ALLOW water
into the appliance.
·DO NOT use soap or chemicals which may damage the housing of the
heater.
·Allow sufficient drying time before operating again.
·Clean the air inlets and outlets regularly with a vacuum cleaner (with a
regular use, at least twice a year).
·When the unit is not in use. we recommend that the heater is re-packed in
its original packaging and stored in a cool, dry place.
Warning: In order to avoid overheating, do not cover the heater.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE
PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC.
At the end of its working life, the product must not be disposed of as urban
waste. It must be taken to a special local authority differentiated waste
collection centre or to a dealer providing this service. Disposing of a
household appliance separately avoids possible negative consequences for
the environment and health, deriving form inappropriate disposal and
enables the constituent materials to be recovered to obtain significant
savings in energy and resources. As a reminder of the need to dispose of
household appliances separately, the product is marked with a crossed-out
wheeled dustbin.

Model Number:R-8068
Item
Symbol
Value
Unit
Item
Unit
Heat output
Typeof heatInput,forelectric
storage local
space heaters only (select one)
Nominal heat
output
Pnom
1.8
kW
Manual heat charge control,
with integrated thermostat
no
Minimum heat
output
(indicative)
Pmin
0.9
kW
Manual heat charge control
with room and/or outdoor
temperature feedback.
no
Maximum
continuous
heat output
Pmax,c
1.8
kW
Electronic heat charge
control with room and/or
outdoor temperature
feedback.
no
Auxiliary
electricity
consumption
Fan assisted heat output
no
Atnominal
heatoutput
elmax
N/A
kW
Type of heat output/room
temperature control (select one)
At minimum
heat output
elmin
N/A
kW
Single stage heat output, no
room temperature control.
no
In standby
mode
elSB
0
kW
Two or more manual
stages, no room
temperature control.
no
With mechanical thermostat
room temperature control.
Yes
With electronic room
temperature control.
no
With electronic room
temperature control plus
daily timer.
no
With electronic temperature
control plus weekly timer.
no
Other control options (multiple
selections
possible)
Room temperature control
with presence detection.
no
Room temperature control
with open window detection.
no
With distance control option.
no
With adaptive start control.
no
With working time limitation.
no
With black bulb sensor.
no
Contact details
VASSILIAS S.A.