ROHO AG3-1410A-1 User manual

©2012 ROHO, Inc. Manufactured by ROHO, Inc. The following are registered trademarks of ROHO, Inc.: AGILITY™, ROHO®, shape tting technology®.
ROHO, Inc. has a policy of continual product improvement and reserves the right to amend specications presented in this guide.
Item #: T20217
Rev: 9/12
Print Date: 9/12
Lift back shell up then tilt it backwards
toward the canes.
Hook lower ends of double hooks onto
the lower pins of the cane brackets.
Lock the latches by pushing both left
and right safety locks toward the center
of the back shell to the LOCKED ( )
position.
Reverse these steps for removing AGILITY.
Quick Setup Guide
Push down on back shell until latches
open and upper ends of the double
hooks wrap around the upper pins.
Latches should be fully down in the
closed position.
( ) Note: UNLOCK safety locks to install the AGILITY.
1
6
Tilt back shell toward the canes until
latches rest on upper pins.
3
2
4 5
AGILITY INSTALLATION
Refer to Operations Manual for complete instructions.
WARNING: DO NOT attach AGILITY with the individual seated in the wheelchair.
BACK CANE HARDWARE INSTALLATION
123
L R
Loosen cane hardware bolt. Press end
of adjustment cylinder and unclip
the pivoting cane band. Rotate cane
bracket away from the cane band.
Clip cane band around the cane as shown
and tighten cane hardware bolt. Repeat on
opposite cane with the other cane hardware.
Ensure that both cane hardware are
evenly aligned and tighten the hardware
bolts using the provided Allen wrench.

TO ADjUST THE ANGLE: Pivot the back
shell back and forth until desired
incline or decline is achieved.
With AGILITY installed on the wheelchair,
loosen the left and right depth and angle
adjustment bolts using the Allen wrench.
DEPTH AND ANGLE ADjUSTMENT
ADjUST SEAT DEPTH: Slide the back shell
forward or backward to the desired depth.
If triangle bracket will not slide, see
TROUBLESHOOTING in the operations manual.
Hold the back shell in position. Tighten
right and left depth and angle adjust-
ment bolts with the Allen wrench.
Make sure depth positions on left and right
sides are equal by comparing the markers
on the top of the triangle brackets.
Make sure the left and right double hooks are
rotated to the same angle by comparing the
markers on the front of the double hooks.
1
5
3
46
See AGILITY Operations Manual for complete instructions including instructions for removing or ipping the AGILITY.
2
WIDTH ADjUSTMENT
Remove AGILITY from the wheelchair to
adjust the width. Remove the nuts at
the end of the width and height adjust-
ment bolts with the wrench. Detach the
triangle brackets from the back shell.
Refer to grooves on top and bottom of
the triangle to match the desired width
position. Slide the triangle bracket
horizontal slots over the at end of the
width and height adjustment bolts.
2
13
Loosen the nuts on the width and height
adjustment bolts. Slide the back shell
up and down in the vertical slots until
the desired height is achieved.
HEIGHT ADjUSTMENT
Install the AGILITY on the wheelchair
according to INSTALLATION. The indi-
vidual may then be seated in the chair.
Count the number of square slots in
the sliding height adjustment bar that
are visible through the vertical slots in
the back shell to ensure that the left
and right back shell hardware are in
the same position.
123
Use the reference grooves on the triangle
brackets to ensure that the width and
height adjustment bolts are in the same
position within the horizontal slots in the
triangle brackets. Replace the nuts on
the width and height adjustment bolts.
Tighten the nuts with the wrench.