Rollplay 12V Mercedes GLE SUV Coupe W489 User manual

1
12V Mercedes GLE SUV Coupe (W489)
Customer Service Guide
MMXV © Copyright RollPlay

2
Customer Service Guide
Contents
CAUTION :
Disconnect the battery before proceeding
with the troubleshooting process
I) Check Battery.........................................................................
II) Check Fuse Condition..............................................................
III) Check Wiring Condition............................................................
IV) Door Replacement...................................................................
V) Gearbox Replacement..............................................................
VI) Warning Stickers......................................................................
VII) Schematic Diagram..................................................................
VIII) Exploded View.........................................................................
3
6
7
14
15
20
23
24

3
Customer Service Guide
I) Check Battery
Operation: Use a Flat head screwdriver to unlock and remove the seat. Locate the
battery harness, unplug the connector, and then use a volt-meter to check the
battery.
Step (1)
Turn and unlock these two knobs
Unlock position
Step (2)

4
Customer Service Guide
I) Check Battery
Step (3)
Unplug the battery connector (WHITE) underneath seat
Step (4)

5
Customer Service Guide
I) Check Battery
Step
(5)
Reading Judgment: 11.5 V ~ 13.4 V –Good condition
10.0 V ~ 11.0 V –Recharge battery
9.5 V –Recharge battery. If after the stipulated
recharging time voltage has not increased,
then replace the battery.
Lower than 9.0 V –Replace the battery.

6
Customer Service Guide
II) Check Fuse Condition
Operation: Look at the Fuse Check Window top of the battery to determine if the fuse
blown out. Keep the battery connected,and turn on the unit with the power
switch.The signal light of fuse will stay “ON”when there is a short circuit to
battery.
Step (1)
Fuse Check Window
If the signal light is “ON”, then that means the fuse
has blown out.Replace the whole battery with a
new one.
Step (2)
Signal light bulb

7
Customer Service Guide
III) Check Wiring Connection
Operation: There are three positions of wiring connections to checked.
A. Foot Pedal : Follow below steps to locate and check the connection.
Use a flat head to snap the Foot Pedal off from the left bottom
side of the car body
Step (1)
Check that the wires on the connecting block are secure.
Step (2)

8
Customer Service Guide
III) Check Wiring Connection
Step
(3)
Snap the Foot Pedal back in after checking and/or repairing
2
1

9
Customer Service Guide
III) Check Wiring Connection
B. Shifter : Locate the Shifter cover below the seat. Unscrew,and lift it up as
shown below.
Step (1)
Unscrew the shifter cover
Step (2)
Use flat head screwdriver to release cover as shown

10
Customer Service Guide
III) Check Wiring Connection
Step (3)
Lift the shifter assembly up from slot
Step (4)
Check that the connecting blocks are properly in place
Reverse above procedures to re-assemble the vehicle