Room & Board BERKLEY User manual

ASSEMBLY INSTRUCTIONS
Keep these instructions for future use
BERKLEY SIDE STORAGE BED
800.486.6554 | roomandboard.com 1/1/21
Recommended Tools and Materials
• Small wrench (included)
• Allen wrench (included)
• #2 Phillips head screwdriver
• Level
This Product Includes
• Headboard
• Footboard
• Drawer box assembly (2)
• Melamine platform panel (2)
• Curved washer (4)
• Threaded rod (4)
• Allen bolt (6)
• Wooden dowel (4)
• ½" nut (4)
• #2 Phillips head wood screws (12)

800.486.6554 | roomandboard.com 1/1/21
1Place both drawer box assemblies next to one another near their final position in the room. Use a level
and adjust the small threaded feet on the underside of each assembly as necessary to ensure the top
surfaces are perfectly flush and level.
Hold the headboard up near desired placement and insert one wooden dowel and one threaded rod into
each side of the headboard.
2

Align the headboard with the drawer box assemblies and insert the dowels and threaded rods on the
headboard into their corresponding holes in the drawer box assemblies. Adjust the leveling feat under the
headboard as necessary. Open the drawers fully and use 2 of the included Allen bolts to connect the bottom of
the headboard.
3
Use the included curved washer and nut to attach to the threaded rod through the oval slot on the interior side
of the side rails.
4
800.486.6554 | roomandboard.com 1/1/21
Repeat the above process for the footboard attachment.
5

800.486.6554 | roomandboard.com 1/1/21
If necessary, drawer alignment can be adjusted by removing the drawer boxes and adjusting the glide settings
on the underside of each drawer. To remove the drawers, pull the tabs located under the front of each drawer.
7
Place the melamine boards on the bed platform and screw in place using the included #2 Philips head screws.
Make sure the screws are fully tightened and flush with the melamine boards to avoid damage to your mattress.
6