Room & Board MODA Crib User manual

CRIB ASSEMBLY INSTRUCTIONS
For MODA Crib
DO NOT USE POWER TOOLS!
Step 1: Lay the Base Panel on the floor. Place one of the End Panels
on the left side of the Base Panel so that the silver metal inserts are facing
inward. Use three Decorative Bolts and Lock Washers to secure
the End Panel to the Base from underneath the Base Panel, but DO NOT
tighten the Bolts completely yet. Repeat this procedure on the right.
Step 2: Attach one of the Sides to the End Panels with four
Decorative Bolts and Lock Washers using the enclosed Allen
Wrench. Place the Bolts through the end slat of the Side and into the
End Panel, but DO NOT tighten completely.
Steps 1 & 2 Attach End Panels and 1 Side
Step 3: Screw a Bolt and Lock Washer in each of the top holes of the 4
middle columns of inserts on the End Panels. Leave the bolts sticking out
at least an inch. This configuration puts the Mattress in the highest position,
which is the height recommended for newborns. To select a lower position, place
the bolts in lower holes. Place the Mattress Support Platform over the
Bolts. The notches in the Platform fit snugly over the Bolts.
Step 4: Attach the other Side to the End Panels as in step 2. Now tighten
all 18 Bolts on crib completely.
BOLT + WASHER
BOLT + WASHER

Conversion to Toddler Bed: The crib mattress should be in lowest
position (Bolts in the lowest holes.) Remove the front Side by undoing
what you did in Step 4. Remember to loosen ALL Decorative Bolts
before attempting to remove the Side. Use the bolts and lock washers
you removed to attach the Toddler Rail as in Step 4.
For Toddler Bed use, the minimum age shall be no less than 15
months and the maximum weight shall not be greater than 50 lb
(22.7kg). The mattress used on the toddler bed shall be a full-size crib
mattress at least 27 ¼ (131cm) by 51 5/8 in (69cm) with a thickness of
no less than 4 in. (11cm) and not exceeding 6 in. (15cm).
Maintenance: Periodically check to make sure all screws, bolts and
fastening devices are tight. Before each usage or assembly, inspect crib
for damaged hardware, loose joints, missing parts or sharp edges. DO
NOT use crib if parts are missing or broken. DO NOT substitute
parts. DO NOT make any alteration to this crib.
Cleaning: Mix a mild solution of gentle dishwashing liquid and water,
apply to crib surface using a soft, clean cloth, then dry all surfaces with
a soft, dry cloth. NO ABRASIVES, SCOURING PADS, STEEL WOOL,
OR COARSE RAGS should be used to clean this fine furniture.
Storage: A Plastic Pouch is attached to the crib spring for storage
of the assembly instructions for future referral. After completing the
assembly, you are advised to read and be aware of all WARNINGS,
CAUTIONS, CLEANING, STORAGE AND MAINTENANCE notices
contained herein. We caution you not to place excess hardware in the
plastic pouch as it could present danger to a child if retrieved and it
could also puncture the crib mattress. When storing crib, use
CAUTION as extreme temperature or humidity changes could be
harmful.
PARTS INCLUDED IN CARTON
1 –BASE PANEL WITH FEET 2 –END PANELS 2 –SIDES 1 –MATTRESS SUPPORT PLATFORM
PARTS INCLUDED IN HARDWARE BAG
18 –DECORATIVE BOLTS (50mm) 1 –BALL END ALLEN WRENCH 1 –Z-WRENCH 18 –LOCK WASHERS

CRIB ASSEMBLY INSTRUCTIONS
For Moda Crib
Read all instructions before assembling crib.
Keep instructions for future use.
WARNING: INFANTS CAN SUFFOCATE
ON SOFT BEDDING. NEVER ADD A PILLOW OR
COMFORTER. NEVER PLACE ADDITIONAL
PADDING UNDER AN INFANT.
To reduce the risk of SIDS, pediatricians recommend healthy
infants be placed on their backs to sleep, unless otherwise
advised by your physician.
Strangulation Hazard:
Strings can cause strangulation! DO NOT place items with a
string around a child’s neck, such as hood strings or pacifier
cords. DO NOT suspend strings over a crib or toddler bed
or attach strings to toys.
To help prevent strangulation tighten all fasteners. A child can
trap parts of the body or clothing on loose fasteners.
DO NOT place crib or toddler bed near window where cords
from blinds or drapes may strangle a child.
Fall Hazard:
When child is able to pull to a standing position, set mattress
to lowest position and remove bumper pads, large toys and
other objects that could serve as steps for climbing out.
Stop using crib when child begins to climb out or reaches the
height of 35 in. (89cm).
CAUTION: ANY MATTRESS USED IN THIS CRIB
SHALL BE AT LEAST 27 ¼ INCHES (69 CM) BY 51 5/8 INCHES
(131 CM) WITH A THICKNESS NOT EXCEEDING 6 INCHES (15
CM).
Check this product for damaged hardware, loose joints, loose
bolts or other fasteners, missing parts, or sharp edges before and
after assembly and frequently during use. Securely tighten loose
bolts and other fasteners. DO NOT use crib if any parts are
missing, damaged or broken. Contact your ROOM & BOARD®
STORE or EL GRECO WOODWORKING for replacement
parts and instructional literature if needed. DO NOT substitute
parts.
If refinishing, use a non-toxic finish specified for children’s
products.
Follow warnings on all products in a crib.
Never use plastic shipping bags or other plastic film as a mattress
covers because they can cause suffocation.
Infants can suffocate in gaps between crib sides and a mattress that
is too small.
PERIODICALLY CHECK TO SEE THAT ALL BOLTS ARE
SECURELY TIGHTENED.
WARNING: FAILURE TO FOLLOW
THESE WARNINGS AND ASSEMBLY INSTRUCTIONS
COULD RESULT IN SERIOUS INJURY OR DEATH.