Room & Board Sill Picture Ledges User manual

SILL PICTURE LEDGES
Keep these instructions for future use
INSTALLATION INSTRUCTIONS
RECOMMENDED TOOLS AND MATERIALS:
Level
3/16” drill bit
#2 Phillips screwdriver
Power drill
Pencil
Tape measure
THIS PRODUCT INCLUDES:
A. B. C.
A. Sill picture ledge assembly (wall mount strip attached)
B. Mounting screws x2
C. Wall anchors x2
The maximum recommended load for this product is 20 pounds. If you are mounting this shelf to a surface
other than drywall, or if you are uncertain about assembly, please contact a professional for help with
installation.
SPECIAL CONSIDERATIONS:
(hardware not to scale)

4600 Olson Memorial Highway | Minneapolis, Minnesota 55422 I www.roomandboard.com I 800.486.6554
4/3/20
1
2
3
4
Separate the wooden wall mount strip from Sill picture ledge assembly by removing the two assembly
screws on the underside of the ledge assembly with a #2 Phillips screwdriver. Save the screws for
reassembly.
Place the wooden wall mount strip on the wall at the ledge’s intended location. Use a level to ensure the
wall mount strip is properly positioned. Use a pencil to make a mark on the wall along the two vertical
edges of the wall mount strip, then use a tape measure to measure the distance of the screw holes from the
edge of the wall mount strip. Make a mark on the wall at that distance in from each edge mark.These marks
will be the mounting screw locations.
Use a power drill and a 3/16” drill bit to drill pilot holes at your mounting screw location marks. If you've
planned your mounting screw locations to correspond with wall studs, there is no need to use the included
wall anchors. Otherwise, use a #2 Phillips screwdriver to screw in the wall anchors until they are flush with
the surface of the wall.
Insert the mounting screws through the large holes in the wall mount strip and use a #2 Phillips screwdriver
to fasten them into the wall anchors. Be sure the wall mount strip is oriented so that the pre-drilled screw
holes are facing the floor.
5
Hold the ledge assembly against the underside of the wall mount strip and use the previously removed
assembly screws to reattach the ledge to the wall mount strip.