Roscoe Medical GN3278 User manual

The purpose of this guide is to assist you in correctly operating and caring for your conductive neck
garment. This device should only be used under the continued supervision of a licensed healthcare
professional. PLEASE READ THIS INSTRUCTION MANUAL COMPLETELY BEFORE USING THIS
GARMENT. Read, understand and practice the warnings and operating instructions. Always follow the
operating instructions prescribed by your healthcare provider.
QUICK REFERENCE GUIDE PAGE 1
Conductive Neck Garment
Two (2) Pigtail Snap Connectors
1
2
CONDUCTIVE
NECK GARMENT
For more information about your Conductive Garment, please visit us online at roscoemedical.com or call 1-800-871-7858.
WARNINGS:
• For single patient use only.
• Do NOT apply to broken skin.
Should a skin rash occur,
discontinue use and contact your
physician.
• Do NOT stimulate while driving
a motorized vehicle or operating
machinery.
• Conductive garments should
be used with electrical sources
designed and approved for
medical electrical stimulation.
• Do NOT use on patients with
pacemakers.
• Do NOT place or operate the
garment around the FRONT of the
neck.
• Remove all jewelry prior to use.
• Always use a conductive spray or
water with your garment, or you
many experience an unpleasant
stinging sensation.
CARING AND CLEANING
• After use, hand wash in cold water only.
• Dry at at room temperature only. Do not place in a dryer or use an iron on the garment.
• Do not use bleach.
Back
1
Front
2
Conductive Neck Garment

2
QUICK REFERENCE GUIDE PAGE 2
Generously moisten the silver strips on the inside of the garment with a conductive spray or with
water. The moisture acts coupling substance and ensures the eectiveness of the treatment.
Connect the pigtail snap connectors to the
conductive garment as pictured.
Be sure to have them securely in place.
1APPLY CONDUCTIVE SPRAY OR WATER
ON SILVER STRIPS ON INSIDE OF GARMENT
4
5PLUG LEAD WIRES INTO STIMULATOR
AND BEGIN TREATMENT
Be sure the electrical stimulator is o. Securely plug the lead wires into
the stimulator. Following the treatment provided by your practitioner,
turn the stimulator on and adjust as directed by practitioner.
Conductive Neck Garment
CONNECT PIGTAIL
SNAP CONNECTORS
PLUG LEAD WIRES INTO SNAP
CONNECTORS
Insert the pins of the lead wires into the ends of pigtail snap connectors
that are connected to the garment. Make sure no metal is visible.
PLACE CONDUCTIVE GARMENT ON
NECK
Remove all jewelry from the area that will
be covered by the garment. Clean the skin
thoroughly with soap and water.
Place the Conductive Neck Garment on the
back of the neck area with the pigtail lead
wires facing downward as shown below.
Securing in place using the Velcro™fastener
that is sewn into the ends of the garment.
Make sure the garment is placed and
conforms directly on the skin.
3
6CLEANING INSTRUCTIONS
After use, hand wash in cold water only. Dry at at room temperature
only. Do not place in a dryer or use an iron on the garment. Do not use
bleach.
For more information about your Conductive Garment, please visit us online at roscoemedical.com or call 1-800-871-7858.