ROSE DISPLAYS ANOGOTCHA ROUND WITH SLATWALL User manual

Parts
Step 1
Insert T-Top Gotcha Holder into AnoGotcha
Shell. Fig. 1
Step 2
Push end caps into place. Fig. 2
Step 3
Snap the AnoGotcha Holder completely
open so that hinge is turned up as far as
possible. Insert poster into holder until top of
poster meets top of holder. To close snap the
AnoGotcha Holder shut. Fig. 3
With large or curling graphics, it may be
easier to insert graphic at one end and slide
into holder from one end to another.
Step 4
Insert hangers into upper portion
of slatwall. Hangers will rest on lower portion
of slatwall. Fig. 4
Note: To ensure that the frame hangs level
use two hangers placed an equal distance in
from each side of the frame.
Step 5
Place the AnoGotcha on the hangers using
the bottom channel of the top rail. Fig. 5
Important note:
Please save and reuse the AnoGotcha Holder,
End Caps and sSlatwall Hangers for future
projects.
Instruction Sheet
AnoGotcha™
Instructions for Hanging
Incept-9.9.02
AnoGotcha™is a trademark and Gotcha®is a registered trademark of Rose
Displays, Ltd. Neither the manufacturer nor any sales agent may be held
liable for injury, loss or damage resulting from the use
of these products. Part #02INSAnoGotchaSlatwall
Figure 4
Figure 2Figure 1
35 Congress Street, Salem, MA 01970
Tel# [phone] Fax# [phone]
e-mail:[e-mail]
Figure 3
End Caps
06-5525
AnoGotcha Shell
12AG400 T-Top Gotcha
Slatwall Hangers
06-6068
Figure 5

Parts
Step 1
Insert T-Top Gotcha Holder into AnoGotcha
Shell. Fig. 1
Step 2
Push end caps into place. Fig. 2
Step 3
Snap the AnoGotcha Holder completely
open so that hinge is turned up as far as
possible. Insert poster into holder until top of
poster meets top of holder. To close snap the
AnoGotcha Holder shut. Fig. 3
With large or curling graphics, it may be
easier to insert graphic at one end and slide
into holder from one end to another.
Step 4
Insert hangers into upper portion
of slatwall. Hangers will rest on lower portion
of slatwall. Fig. 4
Note: To ensure that the frame hangs level
use two hangers placed an equal distance in
from each side of the frame.
Step 5
Place the AnoGotcha on the hangers using
the bottom channel of the top rail. Fig. 5
Important note:
Please save and reuse the AnoGotcha Holder,
End Caps and sSlatwall Hangers for future
projects.
Instruction Sheet
AnoGotcha™
Instructions for Hanging
Incept-9.9.02
AnoGotcha™is a trademark and Gotcha®is a registered trademark of Rose
Displays, Ltd. Neither the manufacturer nor any sales agent may be held
liable for injury, loss or damage resulting from the use
of these products. Part #02INSAnoGotchaSlatwall
Figure 4
Figure 2Figure 1
Figure 3
End Caps
06-5525
AnoGotcha Shell
12AG400 T-Top Gotcha
Slatwall Hangers
06-6068
Figure 5