ROSE DISPLAYS ECONOSTAND WITH ANOQUICK User manual

Parts
Instruction Sheet
Step 1
Assemble bottom holder bracket onto
lower pole section (this is the thicker
section of the pole).
Step 2
Screw pole onto baseplate. Tighten
securely.
Step 3
Place stand upright. Using thumbscrew
at top of pole, attach top holder
bracket onto pole top.
Step 4
Prepare edges of graphic. Place the
graphic on tablettop with one edge at
the table edge. Using the AnoQuick
Holder run it across the graphic edge,
crushing it slightly. Fig. 4 Push the
holder on the graphic.
Step 5
Slide AnoQuick Holder onto brackets.
Install endcaps after assembly to
brackets.
Step 6
Adjust height of stand as necessary.
EconoStand™
Instructions For Assembly
Revised-9.10.02
EconoStand
components
The AnoQuickTM and EconostandTM are trademarks of Rose Displays, Ltd.
Neither the manufacturer nor any sales agent may be held liable for injury,
loss or damage resulting from the use of these products.
Part#02INSEcono/AnoQuick
1 2
3 4
5 6
2a
Base Plate
Pole
Top
Holder Bracket
Bottom
Holder Bracket
Top
Thumb
Screw
AnoQuick
12A300
End Caps
06-5525
35 Congress Street, Salem MA 01970
Tel# [phone] Fax# [phone]
e-mail:[e-mail]

The AnoQuick and EconoStand are trademarks of Rose Displays, Ltd.
Neither the manufacturer nor any sales agent may be held liable for
injury, loss or damage resulting from the use of these products.
Part #02INSEcono/AnoQuick
Parts
Instruction Sheet
Step 1
Assemble bottom holder bracket onto
lower pole section (this is the thicker
section of the pole).
Step 2
Screw pole onto baseplate. Tighten
securely.
Step 3
Place stand upright. Using thumbscrew
at top of pole, attach top holder
bracket onto pole top.
Step 4
Prepare edges of graphic. Place the
graphic on tablettop with one edge at
the table edge. Using the AnoQuick
Holder run it across the graphic edge,
crushing it slightly. Fig. 4 Push the
holder on the graphic.
Step 5
Slide AnoQuick Holder onto brackets.
Install endcaps after assembly to
brackets.
Step 6
Adjust height of stand as necessary.
EconoStand™
Instructions For Assembly
Revised-9.10.02
EconoStand
components
1 2
3 4
5 6
2a
Base Plate
Pole
Top
Holder Bracket
Bottom
Holder Bracket
Top
Thumb
Screw
AnoQuick
12A300
End Caps
06-5525