Royal Sovereign ARP-1000EX User manual

Royal Centurian Inc.
PORTABLE AIR CONDITIONER
ACONDICIONADOR DE AIRE PORTÁTIL
Read and retain these instructions for future reference
ARP-900EX / 1000EX / 1200EX
OWNER’S MANUAL
ARP-900EX / 1000EX / 1200EX
PORTABLE AIR CONDITIONER

PORTABLE AIR CONDITIONER
Model ARP-900EX / 1000EX / 1200EX

Accessories
10. Extendable window spacer - To fill extra space in window (1)
11. Exhaust hose/Inlet hose- (2)
12. Hose adapter- For insertion over each end of hose (4)
13. Window spacer connector - For insertion into the hose adapter
and mounted onto the extendable window spacer (2).
14. Cover- Used to place over the window spacer connector to block air
when unit is not in use or for off season (2).
3
1
25
6
8
9
7
3
4Back
5.Air filter
6. Air Inlet (Evaporator)
7. Exhaust Air Outlet
8. Air Inlet
9. Drain Plug and Drain
PARTS
10
11
12 14
13
Front
1. Control Panel
2. Cooling Air Outlet
3. Remote Signal Receiver
4. Handle

SAFETY PRECAUTIONS
1.Only use in the upright position on a flat, level surface at least 20"/50cm from any object.
2.WARNING- Please read the warning label on the power cord before handling the unit.
3.Do not place objects on top or in front of the unit.
4.Closely supervise children and pets while unit is in use.
5.For indoor use only.
6.Turn off and unplug the unit when it is not in use.
7.Do not use in wet environments.
8.Do not pull the unit by the cord.
9.If the power cord is damaged, it must be replaced by an
electrician to avoid hazard or injury.
FOR MAXIMUM EFFICENCY
1.Do not exceed the recommended room size
of 400 sq. feet.
2.Keep doors and windows closed.
3.Keep curtains or blinds closed during the sunniest
part of the day.
4.Keep filters clean.
5.Once room has reached the desired condition,
reduce the temperature.
4
ARP-900EX / 1000EX / 1200EX

INSTALLATION
1. Connect one hose adapter to each end of the 2 hoses.
2. Insert one hose into the exhaust air outlet and one hose into the air inlet.
3. Insert the window spacer into the window.
4. Mount the window spacer connector covering the holes on the extendable
window spacer.
5. Insert each hose into the window spacer.
NOTE: The hose may be extended from 1-5 ft/300-1500mm but for maximum efficiency use the shortest length possible.
For best results do not let the exhaust hose exceed a 45° angle.
5

6
ON/OFF
Press this button to start and stop the unit..
MODE
Press this button to select the Fan, Cool or Dehumidify mode.
The Fan mode will allow you to select a Speed of High, Medium or Low.
The Cool mode will allow you to select a Speed of High, Medium or Low or a specific temperature by
using the UP/DOWN buttons between 61°F-89°F (16°C -32°C).
The Dehumidify mode will allow you to dehumidify the room and remove excess moisture.
OPERATION/FUNCTIONS
Control panel
1. Water full indicator light
2. Cool indicator light
3. Dehumidify indicator light
4. Fan indicator light
5. Power button
6. Mode button (Cool, Dehumidify, Fan)
7. Speed button (High, Medium, Low)
8. High indicator light
9. Medium indicator light
10. Low indicator light
11. Display
12. Temperature/Timer DOWN button
13. Temperature/Timer UP button
14. Timer button
15. Room temperature indicator light
16. Set temperature indicator light
17. Timer indicator light
ARP-900EX / 1000EX / 1200EX

SPEED
Press the SPEED button to select a High, Medium or Low setting.
TIMER (1-12 Hours)
The timer button will allow you to turn the unit ON or OFF without even being in the room.
If the unit is OFF- Press the TIMER button on the control panel or remote control (Timer indicator light will be lit).
Then press the or buttons on the control panel or the remote until you select the quantity of
hours (1-12) you want the unit turned on in. Example- If you want the unit to turn on in 3 hours then press the button until it shows 3,
the unit will automatically turn on in 3 hours.
If the unit is ON- Press the TIMER button on the control panel or remote control (Timer indicator light will be lit).
Then press the or buttons until you select the quantity of hours (1-12) you want the unit turned off in.
Example- If you want the unit to turn off after 4 hours then press the button until it shows 4, the unit will automatically turn off in 4
hours.
Water Full Indicator Light
When the water tank is full the water full indicator light will light up and the machine will automatically turn off.
Drain any water from the unit by removing the drain plug and emptying the water through the drain port into a suitable container.
7

8
Power button
Temperature/Timer UP Button
Temperature/Timer DOWN button
Timer button
Mode button (Cool, Dehumidify, Fan)
Speed button (High, Medium, Low) Fahrenheit/Celsius button
LCD Display
REMOTE CONTROL
ARP-900EX / 1000EX / 1200EX

9
MAINTENANCE
Always unplug the air conditioner from the outlet before cleaning. To maximize the efficiency of the air conditioner,
clean regularly.
Cleaning the Filte
Remove the filter from the back of the unit. Use a vacuum cleaner or gently tap the filter to remove loose dust and dirt,
then rinse thoroughly under warm running water. Dry thoroughly before returning the filter to the correct position.
NOTE : Never operate the unit without the filter.
Cleaning the Housing
Use a soft, damp cloth to wipe the body clean.
Never use chemicals, gasoline, detergents, chemically treated cloths or other cleansing solutions as this could possibly
damage the housing.
Storage
• Drain any water from the unit by removing the drain plug and emptying the water through the drain port into a suitable
container.
• Clean the filter
• If possible, place back in its original carton or cover for storage.
• Always keep the unit in the upright position

10
TROUBLE SHOOTING
The air conditioner does not run
The machine is not cooling very well
The unit is vibrating
Sudden noise
Problem
Check to see if it is plugged in.
Check to see the power is on.
Is there direct sunlight.
Close all curtains and blinds.
Check to make sure there are no doors/windows open.
Check to make sure nothing that produces heat is on.
The unit may be on an uneven surface.
Make sure it is on a flat surface.
The compressor may have turned on. This is normal.
Possible Cause/Solution
* NOTE: Never try to repair or dismantle the unit yourself.
ARP-900EX / 1000EX / 1200EX