SAFAVIEH COUTURE Kandiss SFV5117 User manual

NOTICE
*Please make sure that you have all parts indicated and they are in good condition before you
begin assembly of this item. Refer to part list and hardware list below for guidance.
*This item should be assembled on a soft surface to prevent scratching the finish during assembly.
*This item may require periodic tightening.
*If you are having difficulty, our friendly Customer Care team is always here to help.
Please email customersuppo[email protected]m
PREPARATION
Model# SFV5117
*Before beginning assembly of product, make sure all parts are present. Compare parts with
Product Dimensions: 55.50" W x 18.10" D x 16.70" H
part contents list and hardware contents list.
*If any part is missing or damaged, do not attempt to assemble the product.
*Estimated Assembly Time: 10 minutes.
*Tools Required for Assembly (included): Allen Key
CARE AND MAINTENANCE
Spot clean using a mild water-free solvent. Only a professional cleaner should undertake
a complete overall cleaning.
The use of steam or water-based cleaners may cause excessive shrinking or staining.
Parts List and Hardware List
PIECE DESCRIPTION PICTURE QUANTITY
ASeat 1X
BLegs 2X
HW1 Bolt M8 x 90MM 4X
HW2 Spring Washer 8.5 mm 4X
Weight Capacity: 550 lbs
HW3 Flat Washer 9 mm 4X
WARNING: DO NOT STAND ON BENCH
HW4 Allen Key 1X
WARNING: DO NOT OVER TORQUE BOLTS

PREPARATION
*Before beginning assembly of product, make sure all parts are present. Compare parts with part contents list and hardware contents list.
*If any part is missing or damaged, do not attempt to assemble the product.
*Estimated Assembly Time: 10 minutes.
*Tools Required for Assembly (included): Allen Key
*If you are having difficulty, our friendly Customer Care team is always here to help. Please email [e-mail]
Legs inside here.
HW4
HW1
HW2
HW3
STEP 1：OPEN THE ZIPPER ON THE BOTTOM OF THE SEAT AND TAKE
OUT LEGS AND HARDWARE.
STEP 2：PUT THE WASHERS ON THE SCREW IN THE ORDER SHOWN IN THE
PICTURE, INSERT THE LEGS AND SCREW IN THE SCREWS BUT DON'T TIGHTEN
COMPLETELY. REPEAT THE SAME STEPS FOR THE OTHER LEG.
STEP 3：PLEASE FIRMLY TIGHTEN SCREWS WITH THE ALLEN KEY.
STEP 4：PUT THE BENCH UPRIGHT AND MAKE SURE ALL LEGS ARE LEVEL.
B
B
A
4X
A
B
B
A
Please remove the small boards first.