SAFAVIEH COUTURE SFV5063-Q User manual

NOTICE
*Please make sure that you have all parts indicated and they are in good condition before you
begin assembly of this item. Refer to part list and hardware list below for guidance.
*This item should be assembled on a soft surface to prevent scratching the finish during assembly.
*This item may require periodic tightening.
*If you are having difficulty, our friendly Customer Care team is always here to help.
Please email customersuppo[email protected]m
PREPARATION
Model# SFV5063-Q
*Before beginning assembly of product, make sure all parts are present. Compare parts with
Product Dimensions: 69.10" W x 89.80" D x 49.20" H
part contents list and hardware contents list.
*If any part is missing or damaged, do not attempt to assemble the product.
*Estimated Assembly Time: 30 minutes.
*Tools Required for Assembly (included): Wrench
CARE AND MAINTENANCE
Spot clean using a mild water-free solvent. Only a professional cleaner should undertake
a complete overall cleaning.
The use of steam or water-based cleaners may cause excessive shrinking or staining.
Parts List and Hardware List
PIECE DESCRIPTION PICTURE QUANTITY CARTON CALL
AHeadboard 1X 1 of 4
BFootboard 1X 3 of 4
CSiderail 2X 2 of 4
DIron Center Support Rail 1X 4 of 4
EIron Slat 5X 4 of 4
FMetal Leg 2X 4 of 4
HW1 Bolt M8 x 20 mm 4X 4 of 4 Weight Capacity: 550 lbs
HW2 Nut M8 12X 4 of 4
HW3 Plastic Cap 17X 4 of 4
WARNING: DO NOT STAND ON BED
HW4 Flat Washer M8 8X 4 of 4
WARNING: DO NOT OVER TORQUE BOLTS
HW5 Wrench 1X 4 of 4

PREPARATION
*Before beginning assembly of product, make sure all parts are present. Compare parts with part contents list and hardware contents list.
*If any part is missing or damaged, do not attempt to assemble the product.
*Estimated Assembly Time: 30 minutes.
*Tools Required for Assembly (included): Wrench
*If you are having difficulty, our friendly Customer Care team is always here to help. Please email [e-mail]
STEP 2：Screw the 2 metal legs(F) onto the long iron center
support rail(D). Insert the plastic cap(HW3) in the iron center
support rail(D).
STEP 4：Insert the remaining 5 iron slats(E) horizontally between
the left and right Sideboards(C). Make sure the plastic caps(HW3)
between the center support rail(D) and each of iron slats(E).
STEP 1：Attach the Siderails(C) to the Headboard(A) and
Footboard(B) by the nuts(HW2) and wrench(HW5).
A
B
C
C
HW5
HW2
HW2
4X
HW5
HW1
HW4
HW4
HW2
F
HW3
D
F
F
2X
STEP 3：Insert the center support rail(D) in the metal brackets on
the Headboard(A) and Footboard(B). Adjust the feet on the metal
legs(F) so that they are resting evenly on the floor. Put the plastic
cap(HW3) in the center support rail(D) evenly .
HW3
A
C
C
B
F
D
A
C
C
B
STEP 5：Congratulations on your successful assembly.
HW3
E