Santec Klassica 70847410 User manual

Rev. 4/21
GENERIC
PERSONAL HAND SHOWER SLIDE BAR
MODEL: SL-142 or 708452
WITH OPTIONAL VARIOUS HAND SHOWERS
1"
24"

Slid e Bar Components
2x Cap
Top Post
Bottom Post
Shower Holder Bracket
0 2
2x Toggle
( 6x30)
2x Screw (ST4X30)
Slide Bar

Step 1:
Insert shower holder bracket onto the slide bar. Press down on the bracket lever to loosen the
grip for ease of insert. The threaded end of the slide bar should be pointed upward.
Installation
0 3
Threaded
Top
Bottom
Press

Step 2:
After determining the slide bar's location on the wall use the bottom post and mark
the hole (hole A) on the wall with a marker. The bottom post can be identified with its
exhaust hole as shown in the right image below.
Marker
6
hole ADrill
Step 3:
Drill hole A on the mark. Inject the silicon into hole A and insert a toggle into it. Secure
the bottom post to the wall using the screw(ST4X30).
Bottom post
Exhaust hole
0 4
Silicon
hole A

0 5
Step 4:
Slightly screw the slide bar into the top post. Leave enough room for a marker and screw to
be inserted through the post as shown below.
Front view offthe top post with
the slide bar slighlty screwed in
Step 5:
Insert the non-threaded end of the slide bar assembly all the way into the bottom post that is
mounted to the wall.

Step 6:
Mark the hole (hole B) with a marker. Remove the slide bar assembly. Proceed to drill hole B on
the mark.
Marker 6
hole BDrill
0 6
Step 7:
Inject the silicon into hole B and insert a toggle into it. Insert back the slide bar assembly all
the way into the bottom post. Secure the top post to the wall using the screw(ST4X30).
hole B
Silicon

Step 8:
Press down on the bracket lever and rotate the slide bar into the top post until it is tightened.
Put the caps onto the posts to cover. Installation is now complete.
0 7
Press

OPTIONAL ASSEMBLY FOR HAND SHOWER
HOSE CONNECTION TO SUPPLY ELBOW
Note: Position supply elbow according to personal preference per
location of water source.
ATTACH THE HOSE PROPERLY BY FOLLOWING THE
INSTRUCTIONS BELOW.
Attach the HEX NUT on the hose to the WATER SOURCE. Attach
the CONICAL NUT at the other end of the hose to the HAND
SHOWER.
Slip the spray assembly into the slotted groove of the Adjustable
Bracket.
Move the adjustable bracket to desired height.
S u p p ly Elbow
0 8