Saris Freedom EX-2 Bike User manual

SuperClamp EX - 2 Bike
4025F

TELL US WHAT YOU THINK
REGISTER YOUR PRODUCT FOR UPDATES

3
LONG FOR THE RIDE
3
Just as no garage is complete without a bicycle, at Saris, we believe no car is
complete withouta bike rack.
Since setting off on this journey nearly 30 years ago, Saris racks have freed
millions of bike-lovers to explore new territory and terrain, take part in group
rides, bike pool to races, and commute to and from work.
And we continue to do so in style.
As the all-time #1 best-selling bike rack, Saris Bones® continues to set the
standard for excellence in design. Today all Saris bicycle racks are intuitive to
load and secure, and guaranteed for life.
Built by cyclists for cyclists in Madison, Wisconsin, we strive to create the
world’s best bike racks.
Because cycling is what we live for.

4
Specifications: 4025F SuperClamp EX
Max = 60 lbs/kg 27
Fit
Guide
Max = 120 lbs/54kg
For use with receiver hitches Class II or higher.

5
Tools Needed: Items Included:
x 1
x 2x 2
M10 x 60 M10
8mm x 2
For 4.5”-5” tires
Adjustable or 19mm and 17mm
#4419 Fat Tire Wheel Trays
x 2
Optional Accessories:

Install receiver and secure with pin and lock.
Note: If your receiver is 1.25” remove the adapter block as shown.
Tools Required: 19mm(3/4’’) Wrench, 5mm Hex Key(to remove
adapter block)
1
INSTALL RACK
EN
6
2”
1.25”

Lay horizontal bar on to receiver plate, lining up front plate with bar and
receiver. Secure with bolts & nuts, using 17mm(9/16”) wrench and 8mm hex
key.
NOTE : Remove rubber tips
Tools Required: 17mm Wrench, 8mm Hex Key
EN
2
7

Slide on outer wheel trays to complete rack assembly. (Wheel tray with
white refl ectors installed on passenger side of vehicle facing away from
the vehicle.)
EN
3
8
A
A
B
B
BB
A
A

Push and hold button to open arm. Push and hold button to slide
hooks up.
1
LOAD BIKES
EN
9

Load bikes. Heaviest bike closest to car. Adjust wheel tray if necessary.
Tighten wheeltray knob.
NOTE: Position arms at ‘‘10:00’’ and ‘‘2:00’’ without contacting bike frame
components.
EN
2
10

Press hooks down onto tires. Once the hook contacts the tire, fi rmly press the
hook down until you hear 1 additional click. Ensure the tires are properly infl
ated and in good condition.
NOTE: For rear fender, 20’’ bikes, bikes over 50 lbs, wheel straps should be
used in the «A» wheel trays(Back Wheel). Bikes between 45’’- 48’’ wheelbase
require two wheel straps.
EN
3
11

To lock bikes press and hold button, pull out lock shank. Be sure lock is
in unlock position before inserting lock shank. To return cable press and
hold button.
EN
4
12

Thread Wheel Strap from bottom through strap slot. Click strap into
place. Use Strap to secure rear wheel to tray.
EN
5
13

Pull handle, tilt rack away from vehicle.
Caution: hold bikes with available hand.
1
HATCH ACCESS
EN
14

Access Hatch.
EN
2
15

Push rack into place, you will hear audible “click” when in place.
EN
3
16

Pull hande, Fold up rack toward vehicle
1
RACK STORAGE
EN
17

18
Technical Specifications
Bike carrier weight: 35lb/ 15.8kg
Permitted load capacity: 120lb/ 54.4kg
Max bike weight: 60 lb/27.2 kg
CAUTIONS:
• All requirements for compatability/fit as stated in the current Saris vehicle/carrier compatability guide must be followed. (Available at any Saris dealer). If your vehicle is not
listed or you have any questions, please call our customer service.
• Read and follow instructions carefully. Save owner’s manual for future reference or parts information. Ensure that any other users of the bicycle carrier are familiar with
their content.
• Drive slowly over speed bumps, 5 to 10 mph max speed.
• It’s the end users responsibility to ensure that use of this product meets all local and state laws.
• When cleaning vehicle and rack, use only water soluble cleaners. Do not take rack through car wash.
• Make sure bike tires are not directly behind exhaust pipe.
• Rack must be installed directly into vehicle hitch receiver. Do not modify the hitch receiver or use hitch extenders.
• Do not mount to any type of trailer or RV including Class B vehicles.
• Prior to usage on the road, remove all loose parts from bicycle, including (but not limited to) child seat, basket, lock, light, pump, etc.
• This carrier is not recommended for off-road use or for use at speed exceeding 70 mph (113 km/h).
• The handling characteristics of a vehicle will change when a rear bicycles carrier is fitted and especially when it is loaded (in particular crosswind sensitivity, handling on
bends and braking). Driving techniques should be altered to allow for these changes, reduce speed, especially on bends and allowing for longer braking distances.
• The vehicle’s total length increases when the bike carrier is attached. The bikes themselves may increase the vehicle’s total width and height. Take care when reversing
and/or entering garages or ferries, etc.
• Remove carrier from vehicle when not in use.
• This carrier is constructed to carry standard-bike-frames. It is not intended for use with tandem or recumbent bicycles.
• Replace any mounting strap at the first sign of wear. Replacement parts are available through your local Saris dealer or call.
EN

19
• Tighten straps regularly during the journey.
• Vehicle should be in good condition in the area at which the hitch is located.
• Do not exceed maximum load capacity of carrier (120 lbs max or 60 lbs max per bike!) Secure properly and adjust for even load distribution, loading the heaviest/biggest
bike first and closest to the vehicle.
• Saris absolves itself of responsibility for any personal injuries or consequential damage to property or wealth caused by incorrect fitting or use.
Warning and Disclaimer:
This carrier has been designed to carry bicycles on specific vehicles. Before installation, user must read and follow current Saris Fit Guide (available through Saris dealer) recommen-
dations and enclosed instructions. Fit recommendations are based on vehicle’s standard features; optional features may affect the fit recommendations. User must attach carrier
correctly to the vehicle, check its attachment before each use, and inspect carrier parts for wear. Carrier’s attachment to the vehicle is critical and beyond the control of the manufac-
turer. Manufacturer and seller expressly disclaim any and all liability for personal injury, property damage or loss, whether direct, indirect, or incidental, resulting from the incorrect
attachment, improper use, inadequate maintenance, or neglect of this carrier.
Check out an excellent selection of bike racks we offer on our website.