SATO CL-408 User manual

CL408/412
Parts List
SATO America, Inc.
10350-A Nations Ford Rd.
Charlotte, NC 28273
Tel [phone]
Fax [phone]
P/N 9001036 REV. C

Copyright 1996
SATO America, Inc.
Charlotte, NC 28273
All rights reserved. No part of this document may be reproduced or issued to
third parties in any form without the express permission of SATO America, Inc.
The materials in this document are provided for general information and are
subject to change without notice. Sato America, Inc. assumes no responsibility
for any errors that may appear.

CL408
Description Page#
Base Cover Assembly 4-10
Frame Assembly 11-13
Thermal Head Assembly 14-16
Ribbon Assembly 17-20
Main PCB Assembly 21-21
Serial Port Option 22-22
Parallel Port Option 23-23
Memory Card Assembly 24-24
(Option)
Dispenser Assembly 25-29
(Option)
Cutter Assembly 30-30
(Option)

CL408/412
4
Base Cover Assembly
Item # Part Number Description Qty
01 PR3770400 Base frame, Use for S/N 61273050 and Lower 1
02 PT6680100 Rubber foot 4
03 PZ0770200 Center frame 1
04 MD4401021 Pan head screw 5
05 PA1771000 Lid 1
06 MD4300621 Pan head screw 4
07 PE1770200 Roller bracket 1
08 PE3770100 Roller (3.1x8x16) 1
09 PB0770100 Post 1
10 PE8770100 Gear (1x34) 1
11 ND0040030 E-snap ring 1
12 MD4401021 Pan head screw 1
13 PB0770400 Post 1
14 PA3741800 Tension bracket 1
15 PB0740900 Shaft (Tension roller) 1
16 PC0740100 Spring (Tension) 1
17 PE3720100 Tension roller 1
18 MD4401021 Pan head screw 1
19 MA0301421 Pan head screw 1
20 MT1300522 Hex nut 1
21 ND0040030 E-snap ring 3
22 PA1772200 PCB bracket 1
23 MD4300621 Pan head screw 2
24 PZ0770100 Rear cover 1
25 MD4300621 Pan head screw 6
26 PE6770800 Memory card cover 1
27 MD4300621 Pan head screw 2
28 PH3683802 Lid 1
29 PT9520100 Nylon rivet 2
30 PA1772100 Cuide plate 1
31 MD4300621 Pan head screw 4
32 PA1773500 Unwind bracket 1
33 PA4520300 Stopper spring 1
34 PE1720300 Label stopper 1
35 MH0300821 P-tight screw 1
36 NA1030022 Plain washer 1
37 MD4300621 Pan head screw 4
38 PA1773300 Motor bracket, Use for S/N 61273050 and Lower 1
39 MD4401021 Pan head screw 2
40 PL1770100 Motor pulley, CL408 only 1

CL408/412
5
Base Cover Assembly
Item # Part Number Description Qty
41 MJ1400524 W-point screw 2
42 RH1770300 Stepping motor 1
43 MD3401221 Pan head screw 4
44 PA1771400 Plate nut 1
45 PE6770200 Connector cover 1
46 MD4300621 Pan head screw 1
47 PZ0770400 Front cover 1
48 PT3770100 Hinge 2
49 MH1300821 P-tight screw 4
50 MA1300622 Flat head screw 4
51 PE6770400 Lens 1
52 PR7770500 Front cover SET 1
53 PE6770300 Switch button 1
54 MH0300821 P-tight screw 2
55 PZ0770300 Logo plate 1
56 PR1340500 Anti static brush 1
57 PA1773000 Latch bracket 1
58 MH0300821 P-tight screw 2
59 PR3770100 Cover RH 1
60 PH2720100 Window 1
61 MT1300522 Hex nut 2
62 NA1030022 Plain washer 2
64 MD4300621 Pan head screw 2
65 PA1772900 Sensor slit 1
66 MD4300621 Pan head screw 1
67 PH1770100 Cover LH 1
68 MD4300621 Pan head screw 4
69 KA500631A Power supply unit (115V) 1
71 MD4300821 Pan head screw 3
72 RH1770000 POW 1 cable 1
73 RH1770600 POW 2 cable 1
74 RJ1771700 KB PCB assy (115V) 1
76 RH1770500 KB cable set 1
77 PE6770600 KB protector 1
78 MD4300621 Pan head screw 3
79 PE6770700 Cable protector 1
80 PR7770300 Motor pulley Assy, CL408 only 1
81 PR7770400 Guide roller 1
82 PA1774300 Lid 1
83 PA6685400 Nut plate 1

CL408/412
6
Base Cover Assembly
Item # Part Number Description Qty
84 MD3201221 Pan head screw 2
85 PA1772900 Sensor slit 1
86 MH0300821 P-tight screw 1
87 HD100321A Fuse (250V 3.15A) 1
88 MD4300621 Pan head screw 2
89 PR7771100 Motor pulley Assy, CL412 only 1
90 PL1770200 Motor pulley, CL412 only 1
91 PR3770500 Base Frame, Use for S/N 70172001 and Higher 1
92 PA2770200 Motor Bracket, Use for S/N 70172001 and Higher 1
93 NA1030022 Plain Washer 2

CL408/412
7
Base Cover Assembly

CL408/412
8
Base Cover Assembly

CL408/412
9
Base Cover Assembly

CL408/412
10
Base Cover Assembly

CL408/412
11
Frame Assembly
Item # Part Number Description Qty
01 PA1772700 Engine frame 1
02 MD4300621 Pan head screw 3
03 MD3401021 Pan head screw 2
04 PA1772800 Side frame 1
05 MD4300621 Pan head screw 2
06 MD4401021 Pan head screw 2
07 PD1770100 Stay 2
08 MD4401021 Pan head screw 4
09 PA1773100 Guide plate 1
10 PB2770200 Collar (M3x6x9.5F) 1
11 PC1770100 Spring (Guide) 1
12 MD4301422 Pan head screw 1
13 PE5680000 Guide shaft 1
14 MH0301221 P-tight screw 1
15 PE1770300 Guide block 1
16 MH0300821 P-tight screw 1
17 PR7770100 Pitch sensor sub 1
18 PE2770500 Collar 1
19 PC1770100 Spring (Guide) 1
20 PE2770400 Collar (6x9x1) 1
21 MH0300821 P-tight screw 1
22 PB0770500 Post 1
23 MT1400722 Hex nut 1
24 NA1040022 Plain washer 1
25 NB0040022 Spring washer 1
26 PE1770400 Latch handle 1
27 PC2770100 Spring (Latch handle) 1
28 PB2770100 Collar (4x6x8.7) 1
29 MD4401421 Pan head screw 1
30 MD4300821 Pan head screw 1
31 PR7770200 Platen, CL408 only 1
32 PA1770800 Clamp (B) 1
33 MD4300621 Pan head screw 2
34 PT8127064 Timing belt, CL408 only 1
35 PA1773200 Tear-off cutter 1
36 PE1770800 Cutter protector 2
37 MD4300821 Pan head screw 2
38 RH1770800 Head open SW 1
39 MD4201221 Pan head screw 2

CL408/412
12
Frame Assembly
Item # Part Number Description Qty
40 PE6770900 Paper guide 1
41 NA1030022 Plain Washer 1
42 PR7771000 Platen Roller, CL412 only 1
43 PT8130064 Timing belt, CL412 only 1

CL408/412
13
Frame Assembly

CL408/412
14
Thermal Head Assembly
Item # Part Number Description Qty
01 PA1772000 Head frame 1
02 MD4401021 Pan head screw 2
03 PA1772500 Head bracket 1
04 PA1771900 Plate (Ribbon adjust) 1
05 MD4300621 Pan head screw 2
06 PA1772300 Adjust plate (A) 1
07 MD4300621 Pan head screw 1
08 PA1771800 Head sub bracket 1
09 MD4300621 Pan head screw 2
10 PA1770600 Adjust plate (B) 1
11 PB2770300 Collar (4x6x7.2F) 1
12 MA0401021 Pan head screw 1
13 PB0770700 Shaft (Head adjust) 1
14 ND0020030 E-snap ring 2
15 PB2770100 Collar (4x6x8.7) 1
16 MD4401421 Pan head screw 1
17 PA1771500 Adjust plate 1
18 PL2720100 Adjust collar 1
19 MD4300821 Pan head screw 1
20 NA1040022 Plain washer 1
21 MD4300821 Pan head screw 1
22 PC0770100 Spring 1
23 PB0770600 Shaft (Head pressure) 1
24 PE1740100 Head pressure bracket 2
25 PE1740200 Head tension pin 2
26 PC1770200 Spring (head) 2
27 PA0740100 Pressure plate 2
28 ND0060030 E-snap ring 4
29 PE2770300 Collar (6x8x4F) 4
30 PB3770100 Roller (6x12x143) 2
31 PB0770300 Shaft (Support) 1
32 MD4300621 Pan head screw 2
33 PR7770600 Latch handle 1
34 NG2201230 Pin 1
35 PR7770700 Head pressure set 1
36 GH000531A Thermal head, CL408 only 1
37 MD4300621 Pan head screw 1
38 RH1770100 HDP cable 1
39 RH1770200 HDS cable 1
40 MD4300621 Pan Head Screw 1
41 GH000521A Thermal head, CL412 only 1

CL408/412
15
Thermal Head Assembly

CL408/412
16
Thermal Head Assembly

CL408/412
17
Ribbon Assembly
Item # Part Number Description Qty
01 PE4730100 Ribbon boss 2
02 PE2720100 Collar (10x12x10) 4
03 PA4690900 Spring 8
04 MH0300521 P-tight screw 8
05 PT2301020 Oilless dry metal 2
06 PA0680400 Disc 2
07 PC1730100 Spring 2
08 PE2730100 Stopper collar 2
09 PB5730100 Adjust screw 2
10 MA0303022 Pan head screw 5
11 MA1300822 Flat head screw 1
12 MT1300522 Hex nut 1
13 MD4300621 Pan head screw 1
14 PB0740602 Ribbon (Shaft) 2
15 PE4720200 Plate holder boss 2
16 MA0301821 Pan head screw 1
17 MA0302522 Pan head screw 1
18 MT1300522 Hex nut 1
19 MH1250621 P-tight screw 4
20 PA0680300 Lining 2
21 PC0740200 Spring 1
22 PA0730100 Guide plate 2
23 PA0730200 Hold plate 2
24 PE1681100 Guide plate (B) 1
25 PE7720100 Disc plate (A) 1
26 PE6720100 Disc plate cover 1
27 MD4300621 Pan head screw 3
28 PA1770500 Sensor bracket 1
29 MD4300621 Pan head screw 1
30 MA0300621 Pan head screw 2
31 RH1740400 Ribbon sensor (SEN4) 1
32 PR4740100 Spring 1
33 MD4300621 Pan head screw 2
34 PA1772600 Ribbon frame 1
35 MD4300621 Pan head screw 4
36 PA1771700 Adjust plate 2
37 MD4300621 Pan head screw 4
38 MD4401021 Pan head screw 2
39 PT1112080 Ball supporter 4
40 PR1720400 Pulley (50) 1

CL408/412
18
Ribbon Assembly
Item # Part Number Description Qty
41 ND0060030 E-snap ring 1
42 PE2770600 Collar (8x10x19) 1
43 PT8170064 Timing belt, CL408 only 1
44 PR1730900 Ribbon boss 2
45 PR1770100 Pulley 1
46 PC0740200 Spring 1
47 MH0300821 P-tight screw 1
48 PA2771300 Spring bracket 1
49 MD4300621 Pan head screw 2
50 PT8155064 Timing belt, CL412 only 1

CL408/412
19
Ribbon Assembly

CL408/412
20
Ribbon Assembly