Savaria V1504 User manual

SERVICES INDUSTRIELS
SAVARIA INC.
V-1504
OWNER’S MANUAL
07/2003
-3-

OPERATION OF THE V-1504
1.0 0PERATING THE V-1504
Insert the key and turn it in the operating position on any call/send control
(FIGURE 1.0). The key is in the operating position when it can not be pulled out.
Always take the key out when the unit is not in operation. Apply constant
pressure on the appropriate button to call the platform to the landing. The V-1504
will not move if one the doors is open.
FIGURE 1.0 (The call station on your unit may differ from the one shown)
2.0 OPENING THE DOOR
2.1 Mechanical (GAL) locks
The door will unlock automatically when the platform reaches the landing.
2.2 Electric strikes
The door will unlock automatically for a few seconds when the platform
reaches the landing. If you need to reopen the door after the delay is over,
turn the key on and depress the call button once again. This will unlock the
door once again.

3.0 CAB CONTROLS
FIGURE 2.0
-Key switch :Needs to be on to activate the operating buttons.
-Up button :Will move the platform in the up direction.
-Down button :Will move the platform in the down direction.
-Emergency stop : (Optional equipment) Will stop the platform instantly.
Overrides the call stations. The alarm will go on.
-Alarm button :(Optional equipment) Will activate the alarm.
4.0 SAFETY DEVICES
Underpan sensor :(Optional equipment) Located under the platform, it will
stop it if something is hit during the down travel.
UP
BUTTON
DOWN
BUTTON
KEY SWITCH ALARM BUTTON
EMERGENCY
STOP

Door contacts :Will prevent the platform from moving with any of the
doors opened.
5.0 EMERGENCY DOOR OPENING
5.1 GAL LOCK
The door can be opened manually using a special key into the round pin on
the front of the lock (see figure 3.0) This key is for emergency use only. It
should always be kept in a safe place and used by trained personnel
only.
5.2 DOOR STRIKE ON DOORS PROVIDED BY SAVARIA
The door can be opened manually using a ¼ inch allen key through the
front hole in the door (see figure 4.0) This key is for emergency use only.
It should always be kept in a safe place and used by trained personnel
only.
5.3 DOOR STRIKE ON DOORS PROVIDED BY OTHERS
See your dealer for appropriate instructions.
FIGURE 3.0

FIGURE 4.0
6.0 REMOTE EMERGENCY MANUAL LOWERING DEVICE
6.1 120V AC PUMP
The manual lowering box is located on the side of the V-1504. When you
pull on the steel cable located inside the manual lowering box, the platform
comes down. This mechanism should be used in case of emergency
only.
FIGURE 5.0

6.2 12V DC PUMP
A key switch, allowing to lower the platform manually, is located on the
side of the V-1504. Insert the key (the same one than for the call/send
control) and turn it in the operating position to lower the platform. This
mechanism should be used in case of emergency only.
7.0 MAINTENANCE
EVERY TWO MONTHS : -Verification of the door contacts.
Door strike system :
-The lift should not move if any one
of the doors is not closed and
locked.
Interlock (GAL) system :
-The lift should not move if any one
of the doors is not closed.
-The lift should not move beyond
the door zone (usually less the
four inches away from the landing
in either direction) if the door is not
locked. Hold the door unlocked by
using the interlock key.
-Verification of the underpan sensor (if
equipped).
These verifications can be made by the owner.
EVERY SIX MONTHS : -Verification of all the suspension system.

-chains
-connecting links
-chain pulleys and shafts
-parts holding the chains on the rollers
supports
-chain tensioners on the rail (make sure
they are tight)
-cylinder head (cotter pins, cracks, welds)
-state of the rollers
-up relays
If you have two up relays
(solenoids or contactors), make
sure one of them is not stuck in
the activated position. Use a
multimeter to verify that every N.O.
contact is open when the relays
are not being activated.
-Safety brake : see Complementary reference of
installation manual for procedure.
-Oil leaks
-Rollers
-Battery fluid level (optional system)
These procedures must be performed by qualified technicians.

8 .0 Diagnosis
-Platform goes up but does not come down :
-Verify the underpan sensor (if equipped). Pull down on it to
ensure the pan is not stuck in the activated position.
-Platform goes down but does not go up :
-Verify the power supply (breaker, cord, battery etc.).
-Platform does not move :
-Verify if the key is on.
-Verify if the doors are closed.
-Verify if the emergency stop is pushed in. It should be pulled
out.
-If the platform is at the top landing, verify the underpan sensor
as explained above.

30 MONTH LIMITED WARRANTY
SERVICES INDUSTRIELS SAVARIA INC. warrants to the original consumer purchaser
of this Savaria lift, that the company will repair or exchange, at its option, any part of the
lift that fails by reason of defective material or workmanship as follows:
ØRepair or replace parts for a period of 30 months from date of lift purchase.
This warranty does not cover labour charges incurred in the removal, repair or
replacement of parts.
To obtain warranty service, you must promptly notify the Savaria dealer from whom the
lift was purchased, within the warranty period.
This Warranty does not cover:
Batteries and malfunction or damage to lift parts caused by accident, misuse, abuse or
lack of proper maintenance, neglect, improper adjustment, modification, alteration, the
structural condition of your building, overloading, failure to follow the lift operating
instructions, or acts of God (i.e. weather, lightning, flood, etc.)
This warranty is void if:
ØLift has been installed or maintained by someone other than an authorized Savaria
dealer.
ØLift has been modified or altered in any respect from its original design without
written authorization by Services Industriels Savaria Inc.
ØThe user does not join a preventive maintenance program offered by an authorized
Savaria dealer and does not have the lift inspected at least once every 6 months or
more frequent as use or environment dictates.