Schlage BE469 User manual

*24156804*
24156804
Touchscreen Deadbolt with Alarm
THICK DOOR KIT INSTALLATION INSTRUCTIONS
MODEL BE469
1 Determine the thickness of your door.
2 Choose Screws and Tailpiece Length
2a Select the screws using the chart below.
Door
Thickness
Screw Length
(Actual Size)
2Z\,” - 2Z\v”
1M\,” - 2”
2b Select the tailpiece length, using the chart below.
Door
Thickness
Tailpiece Length
(Actual Size)
2Z\,” - 2Z\v”
1M\,” - 2”
3 Replace the Tailpiece
3a Remove the cylinder screw from the Touchscreen.
3b Remove the cylinder from the Touchscreen.
3c Remove the cylinder cap, washer and tailpiece.
Use a paperclip or similar to press and
hold down the pin. Then unscrew the cap.
The washer and tailpiece can then easily
be removed. Leave the pin in place.
Cap
Pin
Washer
Tailpiece
Door Thickness
1M\,” to 2Z\v”
Break off and discard
This kit is used to t the Touchscreen Deadbolt with Alarm to doors that are between 1M\,” and 2Z\v” thick.
LIf you are uncomfortable performing these steps, call a locksmith for assistance.

© 2012 Ingersoll Rand
Printed in Country
24156804 Rev. 10/12-a2
3d Install the new tailpiece, washer and cylinder cap.
3e Install the cylinder back into the Touchscreen.
3f Replace the cylinder screw.
4 Replace the Cable
4a Remove the spacer screw from the Touchscreen.
4b Remove the spacer from the Touchscreen.
4c Remove the existing cable from the Touchscreen and
replace it with the longer cable.
4d Reroute cable and reinstall spacer.
5 Install the lock.
Install the lock as detailed in the Installation Guide, using the longer
screws you selected in step 2a.
Reinstall all pieces and screw the cap into
place. Do not overtighten the cap!
NOTE: If you are installing
the lock on a door with
a 1Z\x” (38 mm) hole, do
not reinstall the spacer.
NEED HELP?
Please call customer support before returning the product
to the store.
Toll-Free Calling
From:
U.S.A.: [phone]
Canada: [phone]
Mexico: 018005067866
Visit our web site for videos, FAQs and more: answers.schlage.com