Schlage B250PD User manual

*P513-174*
P513-174
B-Series Single Cylinder
Lock
Parts Included
• (2) Keys
• (1) Cylinder
• (1) M\zn”(11 mm) ring &
hardened steel insert
• (1) Z\,”(3 mm) ring &
hardened steel insert
• (1) Driver bar
• (1) Latch
• (2) Mounting screws,
cylinders
• (1) Strike
• (1) Strike dust box
• (1) Strike reinforcer
• (2) 3” (76 mm) mounting
screws, reinforcer
• (4) Mounting screws, latch
and strike
• (1) Thumbturn
Depending on size ordered, may include (2) Z\,”(3 mm) rings and
hardened steel inserts.
NOTE:
Hollow metal doors must be properly reinforced for latch
support. If door reinforcement is not furnished, contact door
manufacturer, or use Schlage reinforcer #37-001 (specify door
thickness)
1 Select rings and inserts.
Use chart to choose rings and inserts for door thickness
adjustment.
Door Thickness 5 Pin Cylinder 6 Pin Cylinder
1C\,”(35 mm) B and A B and (2) A
1C\v”(44 mm) BB and A
A B 5 Pin 6 Pin
Ring Insert Ring Insert 1C\zn”(30 mm) 1B\zn”(33 mm)
5 Pin 6 Pin
1C\,”(35 mm)
door
1C\v”(44 mm)
door
1C\,”(35 mm)
door
1C\v”(44 mm)
door
2 Prepare the door.
2a Mark centerline on door face and edge.
2b Place template on door and drill a 1Z\x”(38 mm)
hole through the door face (from both sides to avoid
damaging wood).
Drill a 1” (25 mm) hole in door edge. Drill C\,” (10 mm) deeper
as illustrated.
C\,”(10 mm) deeper
1” (25 mm) Hole
1Z\x”(38 mm) Hole
3 Install latch.
3a Rotate to adjust latch so that bolt faces door jamb.
3b Insert latch into hole. Line up and trace around
faceplate.
Use chisel to remove wood until the faceplate ts ush when latch
is fully inserted.
Installation InstructionsModel B250PD

© Allegion 2014
Printed in U.S.A.
P513-174 Rev. 01/14-e
3c Install latch with provided screws.
4 Prepare door jamb.
4a Locate exact centerline of latch and mark centerline on
door jamb.
Mark drill points Z\v”(6 mm) above and below horizontal
centerline. Drill two (2) overlapping M\,”(22 mm) holes, ZZ\zn”
(17 mm) deep.
Clean out holes for strike box. Use strike as pattern for
cutout. Use chisel to remove wood Z\v”(6 mm) deep.
4b Mark and drill C\zn”(4 mm) pilot holes for 3” wood
screws.
Install reinforcer, dust box, and strike with provided screws.
5 Install cylinder.
5a Insert driver bar into cylinder.
5b With key removed, insert cylinder into rings (See Step
1) and guide driver bar into slot in latch.
Screw mounting screws from thumbturn through the inside
cylinder and tighten evenly.
Z\v”(6 mm) deep
M\,”(22 mm) Hole
ZZ\zn”(17 mm) deep
Z\v”(6 mm)
Customer Service
1-877-671-7011 www.allegion.com/us