Sealey TDMCHB User manual

INSTRUCTIONS FOR
TIE DOWN - MOTORCYCLE HANDLEBAR
MODEL NO: TDMCHB
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
I
MPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGEAND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
9When selecting web lashings (tie downs) consideration must be
given to the required lashing capacity, taking into account the
mode of use and the nature of the load to be secured.
9Tie downs must be strong enough and of the correct length for
the mode of use.
9Take care that the load is stable when the tie down is released.
9Avoid exposure of the tie down to chemicals.
8DO NOT use if tie down is damaged. A visual inspection before
use is recommended.
9Avoid sharp edges. Protect tie downs by using sleeves or
corner protectors.
8DO NOT overload.
8DO NOT use if knotted.
2. INTRODUCTION
Manufactured from polyester webbing with stitched reinforcement around loops. To be used in conjunction with suitable ratchet tie downs.
Suitable for workshop use, to provide safe restraining points for securing motorcycles to a work bench, at-bed or trailer. Simple cam buckle
fastener tensions the webbing to provide superior load restraint.
3. SPECIFICATION
Model No.................................................................TDMCHB
Maximum Tension ........................................................350Kg
Load Test .....................................................................700Kg
Webbing Width.............................................................35mm
Max. Handlebar Restraint Width ................................750mm
4. OPERATION
4.1. Place strap centrally across handle bars.
4.2. Position red section of strap over handle bar grip g.2.
4.3. Place through loop g.3. Pull strap tight.
4.4. Pass end of strap through second loop g.4.
4.5. Let end of strap hang, ready for attaching to xing point. g.5.
4.6. Repeat for second handle bar grip.
4.7. Tighten strap between handle grips g.6.
TDMCHB | Issue 1 02/01/18
Original Language Version
© Jack Sealey Limited
Refer to
instructions
g.1
g.2
g.3
g.4 g.5
g.6
TDMCHB.indd 1 24/01/2018 08:52:58

5. STORAGE
5.1. Always store in a dry place.
TDMCHB | Issue 1 02/01/18
Original Language Version
© Jack Sealey Limited
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 [e-mail] www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
TDMCHB.indd 2 24/01/2018 08:52:59