Sealey MS0381 User manual

CABLE OILER HYDRAULIC TYPE
MODEL NO: MS0381
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
MS0381 Issue 1 06/09/22
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Wear eye
protection
Wear protective
gloves
Wear safety
footwear
Wear protective
clothing
1. SAFETY
WARNING! Ensure health & safety, local authority, and general workshop practice regulations are strictly adhered to when using
this equipment.
9 Familiariseyourselfwithproductapplicationandlimitations,aswellasthespecicpotentialhazardspeculiartothisproduct.
9Maintain the pump station in good condition (use an authorised service agent).
9Replace or repair damaged parts. Use genuine parts only. Non authorised parts will invalidate the warranty.
9Ensure safety eye protection, oil resistant gloves and protective clothing are worn when using this product.
9Keep the work area clean, uncluttered and ensure there is adequate lighting.
9 Maintaincorrectbalanceandfooting.Ensuretheoorisnotslipperyandwearnonslipshoes.
9Keep children and unauthorised persons away from the working area.
9 Afteruse,drainanyuidsfromtheequipmentbeforestorage.
9Dispose of waste liquids in accordance with local authority regulations.
9Keep the oiler clean and store in a safe dry, childproof location.
WARNING! DO NOTallowuncontrolleddischargeofuidsthuspollutingtheenvironment.Allliquidsmustbedisposedof 
according to local authority regulation
2. INTRODUCTION
Hydraulic cable oiler, forces oil between inner and outer cables throughout their entire length leaving them silky smooth. For use on brake,
throttle, speedo, choke, etc. cables. On motorcycle, car, bicycle, lawnmower cables that all require regular oiling as part of their servicing.
Easytouseandcleanertoservicethemostpopularsizecablesbetween6to10mm.Avoidsreplacingcablesthatarewornorseized.
Resulting in smooth operating cables.
3. SPECIFICATION
Model no.: .................................................................MS0381
4. CONTENTS
Item no. Description
1 Body
2 Ram
3 Compression Discs
4 Neoprene Collar
5 Pressure Cap
6 End Cap
1
23
4
5
6

5. OPERATION
5.1. Pass cable over pressure cap (5).
5.2. Assemble the neoprene collar (4) with a compression disc (3) either side.
5.3. Press the cable end into the slots in items 4 and 3 and press the complete arrangement into the base of the body.
5.4. Firmly screw on the pressure cap (5) to ensure a good grip of neoprene collar (4) onto the cable.
5.5. Unscrew ram (2) and endcap (6) fully and remove from body (1). Fill the chamber to within 20mm from its end with the required
lubricant and replace end cap.
5.6. Screw the ram down until lubricant is forced fully through the cable housing.
5.7. Beforeremovingcable,unscrewtheendcap(6)anddraino󰀨surpluslubricant.
MS0381 Issue 1 06/09/22
Original Language Version
© Jack Sealey Limited
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 [e-mail] www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts
without prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
REGISTER YOUR
PURCHASE HERE
31
4
2
5
6