Sealey SA37/95 User manual

TYRE INFLATOR 2.5M HOSE WITH TWIN
CLIP-ON CHUCK
Model no: SA37/95
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
9 Disconnectthetyreinatorfromtheairsupplybeforechangingaccessories,servicingorperforminganymaintenance.
9 Keepchildrenandunauthorisedpersonsawayfromtheworkarea.
9 KeepthegaugeLCDscreenandtyreinatorclean.
9 ReplacedamagedpartswithgenuineSealeyparts.Unauthorisedpartsmaybedangerousandwillinvalidatethewarranty.
9 Checkconditionofthebatteriesregularly.
9 Checktyrepressureswhentheyarecold.
8DO NOTdirectthetyreinatoroutletatyourselforothersincludinganimals.
8DO NOTcarrythetyreinatorbythehose,ortugthehosefromtheairsupply.
8DO NOTusethetyreinatorforataskwhichitisnotdesignedtoperform.
8DO NOToperatethetyreinatorwhenyouaretiredorundertheinuenceofintoxicatingmedicines,drugsoralcohol.
8DO NOToperatethetyreinatorifpartsaremissingortheLCDisdamaged,thiscouldbedangerous.
8DO NOTdroporbumpthetyreinator.
8DO NOTgetthetyreinatorwet.
8DO NOToperatenearapplianceswithstrongmagneticelds,corrosivegassesorcorrosiveliquids.
2. INTRODUCTION
diecastaluminiumbodywithlargerubberbumper.Linearpressurescale,dualcalibratedinpsiandbar,withparallaxcorrection.2.5mFlexible
hosettedwithtwinlock-onairconnector.Suppliedwithaserialnumberedcalibrationcerticate.
3. SPECIFICATION
Model No:................................................................ SA37/95
InletSize:..................................................................1/4”BSP
MaximumAirSupply:...................................... 15bar(218psi)
MinimumAirSupply:........................................ 5.5bar(80psi)
nettWeight:................................................................ 1.31kg
Range:.....................................................0-9.6bar(0-140psi)
4. OPERATION
4.1. TO READ PRESSURE
4.1.1. Placehold-onchucksquarelyandrmlyontotyrevalve,beforeeachpressurereadingfullydepressleverandrelease.
4.1.2. Checkpressuregauge,thedigitaldisplaywillactivateoncethetyrepressureissensed.Ifnopressureissensedthedisplaywillnot
 turnon,pleasepresstriggertoaddairintotyre,beforereadingpressure.
4.2. TO INFLATE
4.2.1. Placehold-onchucksquarelyandrmlyontothevalve.Fullydepressleverforanappropriateperiodthenreleaselevertodisplay
 pressure.Checkpressuregaugeandrepeatprocedureuntilcorrectpressurelevelisachieved.
4.3. TO DEFLATE
4.3.1. Depressleverhalfway(untilaircanbeheardescaping)foranappropriateperiod,fullydepresslevermomentarilythenreleaseto
 displaynewpressure.Checkpressuregaugeandrepeatprocedureuntilcorrectpressurelevelisachieved.
SA37/95Issue124/06/19
Original Language Version
©JackSealeyLimited
Referto
instructions

5. MAINTENANCE
5.1. PERIODIC CHECKS AND MAINTENANCE
 Forlongserviceandaccuracy,thefollowingactionsshouldbecarriedoutattherecommendedintervals.
5.2. WEEKLY - CHECK OPERATION
 Thegaugeshouldbecheckedweeklyforcorrectoperation.Lookforsmoothleveroperationandfast,smoothgaugemovements.
 Checkforleaksfromtyreconnectorseals,andforchangorwearoftheexiblehoses.Removefromserviceifdamaged.
5.3. MONTHLY
 Removeoilscrew(g.1)place2-3dropsoflightoilintothegaugemechanism.
6. TROUBLESHOOTING
 Thisairlinegaugehasbeenengineeredtogiveyearsoftrouble-freeservice.Majorfaultsareoftendueeithertoprolonged 
 mistreatmentortoadirty,excessivelywetairsupply.Thefollowingguidewillenabletheoperatororserviceengineertodiagnose
 andcureanyproblemswhichmayarise.
6.1. AIR LEAKS FROM TYRE CONNECTOR
 Thesealsshouldbereplacedwhenitbecomesdi󰀩culttoobtainaneasy,positiveairtightsealonatyrevalve.Newchucksare 
 availablefromSealeyStockists.
6.2. DAMAGED FLEXIBLE HOSE (GAUGE TO TYRE CONNECTOR)
 Thecompletehoseassemblyshouldbereplacedimmediatelyifanysignofdeepchangorcrackingappears.Ensurethatthe 
 centredlterinthegaugeoutletportdoesnotbecomedislodgedduringreplacement.
6.3. ERRATIC HIGH GAUGE READINGS OR STIFF, JERKY LEVER OPERATIONS
 Causedbyasti󰀨ordamagedvalveassembly.Ifnotcuredbyoilingthevalvemechanismthenreplacethevalveassembly.
6.4. SLOW TYRE INFLATION
 Causedby:.................Lowsupplypressure,or........blockedinletlter,or.......damagedvalvemechanism.
6.5. ERRATIC LOW GAUGE READINGS AND/OR SLUGGISH GAUGE OPERATION - GAUGE DOES NOT RETURN TO ZERO
 Causedbysti󰀨ordamagedgaugemechanism.Thegaugemustbereturnedtoanauthorisedrepaircentreasspecialequipmentis
 requiredtore-checkthecalibrationofthegaugeafterrepair.
Oil Point
g.1
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 [e-mail] www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycleunwantedmaterialsinsteadofdisposingofthemaswaste.Alltools,accessoriesandpackagingshouldbesorted,takento
arecyclingcentreanddisposedofinamannerwhichiscompatiblewiththeenvironment.Whentheproductbecomescompletely
unserviceableandrequiresdisposal,drainanyfluids(ifapplicable)intoapprovedcontainersanddisposeoftheproductandfluids
accordingtolocalregulations.
Note:Itisourpolicytocontinuallyimproveproductsandassuchwereservetherighttoalterdata,specificationsandcomponentpartswithoutprior
notice.
Important:NoLiabilityisacceptedforincorrectuseofthisproduct.
Warranty:Guaranteeis24monthsfrompurchasedate,proofofwhichisrequiredforanyclaim.
SA37/95Issue124/06/19
Original Language Version
©JackSealeyLimited