Seaside Casual Portsmouth 5' Bench 058 User manual

Page 1
REV B
Seaside Casual Furniture | 11 Industrial Drive Coventry, RI 02816 | 800-809-3114 | [e-mail]
1PLEASE READ INSTRUCTIONS COMPLETELY BEFORE BEGINNING.
Carefully remove contents from box. Make sure that all parts and hardware
are included using the Parts List below.
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114
Actual Size
Flat Washer, Lock Washer & Nut
Back Assembly
x 1
Angle Brace
Seat Assembly
x 1
90mm Connector Bolt
Part Code: 4MMALLEN
Actual Size
4mm Allen Wrench
x 1
x 9
x 9ea
Portsmouth 5’ Bench
(058)
Part Code: 316-1/4-20-90HB
x 4
ASSEMBLY INSTRUCTIONS
4mm Allen Wrench (included); #2 Phillips Head Screwdriver; Rubber Mallet.
Tools Required:
Part Code: 316-8X1-3/4PFDS
Actual Size
1-3/4” Phillips Head Screw
x 8
Actual Size
Lower Stretcher
x 1
5/8“
Actual Size
Bungs
x 8
80mm Hex Lag
x 11
Part Code: 316-1/4-10-80HL
Actual Size
Leg Assembly
x 3

Page 2
REV B
2ATTACH LEG ASSEMBLIES TO
SEAT ASSEMBLY
Align Leg
Assemblies
with Seat
S u p p o r t s
as shown, with the hole in the rear leg
facing the rear of the seat. Secure using
(6) 90mm Connector Bolts, Flat washers,
Lock Washers, and Nuts.
Align Back Up-
rights with Legs
and Seat Cleats.
Secure long back
uprights with (2) 90mm Connector Bolts,
Flat Washers, Lock Washers, and Nuts
through holes in outer legs, and (1)
90mm Connector Bolt, Flat Washer, Lock
Washer, and Nut through Mid Back Up-
right into Mid Seat Support. Then use (8)
80mm Hex lags through counter-bored
holes in Back Uprights. Plug all Counter-
bored holes with (8) 5/8” Bungs using a
rubber mallet.
Align Lower
Stretcher with
pilot holes in
Leg Cleats.
Secure using
(3) 80mm Hex Lags.
3ATTACH BACK ASSEMBLY
5ATTACH LOWER STRETCHER
TO LEG ASSEMBLIES
Align Angle Braces
with Leg Cleats and
Seat Supports over
second seat slat
from rear as shown
with counter-bores facing away from
seat. Secure using (8) 1-3/4” Phillips
Head Screws.
4ATTACH ANGLE BRACES
TIGHTEN ALL CONNECTIONS. AVOID OVER TIGHTENING; DOING SO
CAN CAUSE DAMAGE TO THE PRODUCT.
6