Seaside Casual MAD Series User manual

Page 1
281-REV A 282-REV A 283-REV A 284-REV A 285-REV A 286-REV A
Seaside Casual Furniture | 11 Industrial Drive Coventry, RI 02816 | 800-809-3114 | [e-mail]
1PLEASE READ INSTRUCTIONS COMPLETELY BEFORE BEGINNING.
Carefully remove contents from box. Make sure that all parts and hardware
are included using the Parts List below.
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114
Back Assembly
x 1
Front Apron
Rear Apron
80mm Hex Lag
Rear Stretcher
Left and Right Side Assemblies
x 1ea
Part Code: 4MMALLEN
Actual Size
4mm Allen Wrench
x 1
x 1
x 1
MAD Chairs
281 Dining Arm Chair
282 Balcony Arm Chair
283 Bar Arm Chair
284 Dining Side Chair
285 Balcony Side Chair
286 Bar Side Chair
Part Code: 316-1/4-10-80HL
x 1
ASSEMBLY INSTRUCTIONS
4mm Allen Wrench (included); #2 Phillips Head Screwdriver;
(Recommended: Rubber Mallet; High Powered Drill)
Tools Required:
Part Code: 316-8X1-3/4PFDS
Actual Size
1-3/4” Phillips Head Screw
Actual Size
5/8” Bungs
Dining Height x 4
Right Left
Bar and Balcony Only
Seat Assembly
x 1
Bar & Balcony Height x 8
Front Stretcher Assembly
x 1
Bar and Balcony Only
Dining Height x 4
Bar & Balcony Height x 8
Dining Height x 22
Bar & Balcony Height x 28

Page 2
281-REV A 282-REV A 283-REV A 284-REV A 285-REV A 286-REV A
2ATTACH APRONS TO SIDE
ASSEMBLIES
Align Front and Rear
Aprons with notches
in front and rear legs.
Secure with (4) 80mm
Hex Lags through counter-bored holes
in legs, and (4) 1-3/4” Screws through
pockets in Aprons. Plug holes in legs
with 5/8” Bungs.
Align Seat As-
sembly with
Aprons. Secure
with (8) 1-3/4”
Screws through
c o u n t er - s u n k
holes in Aprons.
A t t a c h S i d e
Stretcher to Front
Stretcher using
( 2 ) 1 - 3 / 4 ”
Screws.
3ATTACH APRONS TO SEAT
ASSEMBLY
7ATTACH SIDE STRETCHER TO
FRONT STRETCHER (282 & 283 ONLY)
Secure Seat As-
sembly to Side
Assembly using
(6) 1-3/4” Screws.
4ATTACH SEAT ASSEMBLY TO
SIDES
Align Back Assem-
bly with the notch-
es in the rear legs.
Secure with (4) 1-
3 / 4 ” S c r e w s
through pockets
on Back Stretcher as shown.
5ATTACH BACK ASSEMBLY
Align Front Stretcher
to Front Legs and
Rear Stretcher to Rear
Legs. Secure using (4)
80mm Hex Lags
through counter-bored holes in legs, and
(4) 1-3/4” Screws through pockets in
bottom of Stretchers. Plug holes in Legs
with 5/8” Bungs.
6ATTACH FRONT AND REAR
STRETCHERS (282, 283, 285, 286 ONLY)