Seaside Casual Sonoma 071 User manual

Page 1
071- Rev A
Seaside Casual Furniture | 11 Industrial Drive Coventry, RI 02816 | 800-809-3114 | [e-mail]
1PLEASE READ INSTRUCTIONS COMPLETELY BEFORE BEGINNING.
Carefully remove contents from box. Make sure that all parts and hardware
are included using the Parts List below.
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114
Leg Assemblies
x 3
End Caps
80mm Hex Lag
Stretchers
Seat Assembly
x 1
Part Code: 4MMALLEN
Actual Size
4mm Allen Wrench
x 1
x 1 ea
x 2
x 14
Sonoma 76” Bench
(071)
Part Code: 316-1/4-10-80HL
ASSEMBLY INSTRUCTIONS
4mm Allen Wrench (included); #2 Phillips Head Screwdriver;
Tools Required:
Part Code: 316-8X1-3/4PFDS
Actual Size
1-3/4” Phillips Head Screw
x 26
Actual Size
Angle Braces
x 4

Page 2
071- Rev A
2ATTACH FIRST STRETCHER
TO LEG ASSEMBLIES
Attach stretcher (without the hanger
bolt), with Counter-bores facing up, to
(2) leg assemblies using (4) 80 mm Hex
Lags thru counter-
bored holes in Leg
Assembly into pi-
lot holes in both
sides of Stretcher.
Attach second stretcher (with Hanger
Bolt) by inserting the hanger bolt into
threaded insert on leg assembly and
turning clockwise until snug. Continue
turning until counter-bores are facing
up.
3ATTACH SECOND STRETCH-
ER
Attach Third leg Assembly to second stretcher
with (2) 80mm Hex Lags as shown.
4ATTACH THIRD LEG ASSEMBLY
Align middle leg with mid cleat on Seat. Center
the outer legs and secure using (24) 1-3/4” Phil-
lips Head Screws.
5ATTACH BASE TO SEAT AS-
SEMBLY
Slide Angle Braces under the notch in the cleats
in the Seat Assembly. Turn until aligned with
stretchers. Secure using (8) 80mm lags thru
counter-bores in Stretchers into pilot holes in
Angle Braces.
6ATTACH ANGLE BRACES
Insert End Caps into threaded insert in Leg As-
sembly. Turn clockwise until snug. Continue
turning until in line with the Stretcher. Secure
end caps into legs with (2) 1-3/4” Phillips Head
Screws.
7SECURE END CAPS
Counter-bores