SeaView PMA-DM124-M2 User manual

INSTALLATION
INSTRUCTIONS
For Seaview Modular Dual Mounts:
PMA-DM124-M2
Refer to website for most up to
date instructions and videos.

PARTS INCLUDED
x1 x1x1
x1
x10
x4
TOOLS NEEDED
3/8” = 9mm
3/8” = 9mm 1/2” = 13mm 2” = 50mm
x6
x6
Sudbury Elastomeric
Marine Sealant is
recommended. To
purchase call 800-655-7922
or visit
www.seaviewglobal.com
1

If you are using a Seaview Light Bar with your Dual Mount you do not
use the pin.
1
If you are not using a Seaview Light Bar then insert the pin as shown
below. Insert the white Light Bar Plug and o-ring into the Light Bar
hole in the back of the mount. Make sure it clips onto the pin.
Place the rubber gasket onto the top of the Dual Mount as shown.
2
2

x6
Mount the Seaview Modular Top Plate to the Dual Mount with the
eight bolts that come with the Modular Top Plate.
Then insert the rubber cable grommet into the Modular Top Plate.
Refer to the provided Seaview Top Plate installation instructions for
more information.
3
Place the Dual Mount onto
the mounting surface and
mark the six bolt holes.
4x6
Drill the six bolt holes.
5
3

Using a hole saw, drill a hole to run the cabling through.
6
Insert the rubber cable
grommet under the lower
platform as shown.
7
Route all cables through the Dual Mount.
8
4

Route the additional cables through the lower platform.
9
10 Apply to marine adhesive sealant to the base of the mount.
Place the Dual Mount
onto the mounting
surface.
11
5

x6
x6
x6
x6
13
Apply marine adhesive sealant to the six nylon shoulder
washers and insert them into the base.
12
Use the provided backing plate and your own hardware to
secure the Dual Mount. Apply marine adhesive sealant to all
bolt holes.
6

x4
Attach the marine electronics to the Dual Mount. Use the
remaining four nylon shoulder washers with marine adhesive
sealant when securing the closed dome radar.
14
7
Use the hardware
provided with your
electronics to secure.
15

OPTIONAL ACCESSORIES
Call 800-655-7922 or visit www.seaviewglobal.com for available accessories.
LIGHT BARS
LIGHT BAR TOPS
SPREADER KIT
LTB-R
Fits closed dome radars.
LTBA-7800
Attwood LED
Light.
LTBU1A1197
Light Bar Top
with Perko
Incandescent
Light, can t GPS.
SP2-MOD
Allows user to mount GPS
units or antennas on to a
Seaview Modular Mount.
LTBU1A800
Light Bar Top
with Attwood
LED Light, can t
GPS.
LTB-S
Fits 20” or smaller satdomes.
8
LTBP-1197
Perko Incandescent
Light.

OPTIONAL ACCESSORIES
Call 800-655-7922 or visit www.seaviewglobal.com for available accessories.
CABLE GLANDS
Seaview Cable Glands provide
waterproof cable routing.
9

THIS PAGE INTENTIONALLY LEFT BLANK.
10

Tel: [phone]
www.seaviewglobal.com
EUROPEAN OFFICE
Tel: [phone]
www.seaviewprogress.com 1-090618