SeaView PM5-FMH-8 User manual

INSTALLATION
INSTRUCTIONS
For Seaview Camera Mount:
PM5-FMH-8
WWW.SEAVIEWGLOBAL.COM
Refer to website for most up to
date instructions and videos.

#12 x 1”
1⁄4-20 x 7⁄8”
PARTS INCLUDED
TOOLS NEEDED
x1
x4 x4 x4 x4
x1 x6
1

Mark the four holes for the
base.
Drill the four holes for the
base.
Using a hole saw, cut a hole
for the electronics cable.
1
2
3
2

Route the elecronics cable
through the FLIR adapter
plate and place the camera
on top of the adapter.
Secure the FLIR M100 or
M200 to the adapter with
the supplied hardware.
Refer to FLIR instructions on
how to bolt them together.
Insert the four nuts into the
top plate of the PM5-FMH-8.
Note, this may have already
been done for you.
Place the top mounting plate
onto the PM5-FMH-8. Be
sure that the four mounting
holes are lined up.
4
5
6
3

Place the camera ontop of
the mounting plate, making
sure to line up the six
mounting holes.
Screw the adapter plate to
the PM5-FMH-8 using the
six #12 x 1” screws with a
philips head screwdriver.
Secure the mounting plate to the mount using the four washers and
bolts using an allen wrench.
#12 x 1” 1/4-20 x 7/8”
7
8
9
4

Apply marine adhesive
sealant around the
bottom of the mount.
Be sure to go around
the bolt holes.
Place the mount onto
the mounting surface.
Insert the four nylon
washers into the
base bolt holes. Apply
marine adhesive
sealant around the
nylon washers.
x4
10
11
12
5

THIS PAGE INTENTIONALLY LEFT BLANK.
6

Tel: [phone]
www.seaviewglobal.com
EUROPEAN OFFICE
Tel: [phone]
www.seaviewprogress.com 2-092918