Seitron wi-time User manual

Quick guide ENG
Touch buttons functionalities
Display icons
Heating mode On WiFi connected
WiFi disabled
(blinking icon)
Thermostat not connected to cloud
Device in conguration mode:
waiting for pairing
Tamper Proof mode On
Permanent Manual Mode
Program mode
Cooling mode On
Temporary Manual Mode (until 24)
Technical features
Type: Semi-recessed programmable thermostat
Available Colors: Black or White
Display: color TFT
Power supply: 100..253Vac 50..60Hz
Power absorption: less than 2W
Relay contacts ratings: max 5A @250V
Wi: 802.11 b/g/n
Temperature adjustment range: +5.0..+40.0 °C (±0.1)
Operation mode heating/cooling
Weekly or manual programming (temporary or permanent)
No-frost function
Settable Boost via App only (30-60-90 minutes)
Predisposition for a remote temperature sensor
Clock with buffer battery set via web
Protection rating: IP 30
Size: 122x82x15 mm
Temperatura sotto controllo
Temperature under control
Seitron Smart
App Android and iOS for Smartphone
Go to www.seitron.it for download instruction manual
WARRANTY
In the view of a constant development of their products, the manufacturer reserves
the right for changing technical data and features without prior notice. The consumer is
guaranteed against any lack of conformity according to the European Directive 1999/44/
EC as well as to the manufacturer’s document about the warranty policy. The full text of
warranty is available on request from the seller.
GIW01MR001SE 033296 141019
Long push (at least 1 sec.): ON/OFF
Brief push: returns to the previous menu Menu, Option selection
Temperature increase,
Moving up with the cursor
Temperature decrease,
Moving down with the cursor

WARNING!
• Before making any connections, make sure the mains power is disconnected.
• Device installation and electrical connections must be carried out by qualied
personnel and must comply with the laws in force.
If a thermostat is already present and it needs to be REPLACED, go to Point 2.
If it is a NEW installation skip to Point 3.
Cut off mains power.
Unhook the old thermostat from the wall and
take a picture of the wirings:
the power wires are usually blue and brown,
the boiler control ones are usually black or
gray.
Once the wires are located, unplug them and
remove the old thermostat.
Insert and x the Wi-Time thermostat
to the wall using the provided screws.
Place back the cover by rst hooking it to
the upper side of the plastic base (1) and
then locking it to the lower side clips (2).
The display shows the blinking icon ‘ ‘
Reconnect the mains power to the thermostat.
Dowload the Seitron Smart App
Start the App, login and complete the Wi-time conguration
Unhook and remove the front cover of the Wi-Time,
from its plastic base underneath, applying pressure
on the 2 clips located on the bottom side of the
thermostat and lifting the cover towards the upper
side.
INSTALLATION
1
2
4
5
6
8
7
9
10
3
1
1
2
83 mm
GIW01MR001SE 033296 141019
Connect the wires as shown:
4: Common to Boiler
6: Normally open to Boiler
7: Phase (Usually brown)
8: Neutral (Usually blue)
1-2: Remote room temperature
sensor (Optional)
NL