Seneca MyBoat-WR User manual

User Manual
WR

ACTIVATION CODE

WR

WARNINGS P.06
PRODUCT DESCRIPTION P.07
PACKET CONTENT P.10
CONTROL UNIT OPERATION P.11
SENSOR DESCRIPTION P.12
APP HOME SCREEN P.13
MYBOAT APP DESCRIPTION P.14
CONTROL UNIT INSTALLATION P.22
SENSOR INSTALLATION P.24
CLOUD SERVICE ACTIVATION P.28
TROUBLESHOOTING P.32
TABLE OF CONTENTS
1
2
3
4
5
7
6
8
9
11
10

6MI005220-E MyBoat_WR
• Do not apply dierent voltages or higher voltages than indicated between
terminals, or between any terminal and earth (voltages greater than 50Vdc)
• Do not use the MyBoat-WR control unit if damaged, or if signs of possible
damage are visible on it.
• Do not remove the internal battery.
• Do not use the MyBoat-WR control unit if it runs abnormally.
• Do not touch the MyBoat-WR control unit terminals during use
• For correct use, use the cables supplied.
• Make sure the internal battery is charged if you intend to use the My-
Boat-WR control unit without power
• Use the MyBoat-WR control unit as described in this manual.
• Before each use, refer to the electrical connections shown in the manual.
REFERENCE STANDARDS: ETSI EN 301-489-7
EN 301 511
EN 301 498-1
IEC / EN 60950
CAUTION
WARNING
1 - WARNINGS SAFETY REGULATIONS
Electrical and electronic waste disposal (applicable in the European Union and other countries
with selective waste collection). The symbol on the product or packaging shows that the
product should be taken to an authorised recycling centre for electrical
and electronic waste.
The full content of this manual must be read before any operation. The device is to be exclusively
used by qualied electricians.
Damaged parts must be replaced or repaired
by the manufacturer. The product is sensitive to electrostatic discharge, take
the appropriate countermeasures during any operation.
The warranty expires in case of improper use or tampering with the device or
accessories supplied by the manufacturer, necessary for its correct operation and if
the instructions in this manual have not been followed.

7MI005220-E MyBoat_WR
MyBoat-WR is a monitoring system consisting of a smart
control unit and three sensors for the remote control and
alarm management in real time of small boats, inatables
and whole eets. The system is based on a Cloud platform
oered by Seneca s.r.l. (https://cloud.seneca.it). The price
of the product includes the subscription to the MyBoat
Cloud service for the rst two years from product activa-
tion.
For information and renewal costs of the service, go to
www.seneca.it/myboat-wr .
MyBoat-WR is a service oering the main functions useful
to monitor your boat through immediate consultation and
the practical use of both browser and mobile APP. Using
the app, available in the Apple and Android stores, you can
check your boat while moving, verify the state of the sen-
sors and be warned in real time in case of an alarm (push
notications, SMS or email).
NB: the SMS service can only be managed with SIMs that support
the SMS service
2 - PRODUCT DESCRIPTION
For optimum reception of the GPS signal given by satel-
lites, it is better to place the MyBoat-WR horizontally on a
surface in an area not covered by metal structures.
ASSEMBLY REGULATIONS
ON / OFF power button
Connector for charging and connecting to the
battery sensor
Menu access button
Slot for the SIM / V-SIM by Vodafone
SD card slot
Locker and motor sensor connector
SYMBOLS ON THE ENCLOSURE

8MI005220-E MyBoat_WR
2 - PRODUCT DESCRIPTION
TECHNICAL SPECIFICATIONS
Power supply
Voltage
Absorption
Internal batteries
6 - 15 Vdc mA Max
3.5 W Max
Lithium Ion 3.7 V -1000 mAh, rechargeable
Ambient conditions
Temperature
Humidity
Storage temperature
Protection rating
Seneca recommends use at 0 to 45°C for correct operation
With the power supply present: -20 .. +55°C
With use of the battery (when discharged): -20 .. 45°C. Charging is possible in
the range: 0 .. +45°C
30% – 90% non-condensing.
from -20°C to +20°C < 1 year; from -20°C to +45°C < 3 months; from -20°C to
+60°C < 1 month
IP66
Digital inputs
Type
Maximum frequency
Threshold OFF
Threshold ON
2 inputs (dedicated to the locker and engine status control)
contact
30 Hz
0 - 3 Vdc, I > 1 mA
6 - 24 Vdc, I > 3 mA
Analogue inputs 1 inputs (dedicated to reading the battery voltage)
Display 128x32 LCD Dots with visible area of 39 mm x 8.6 mm
CPU 100 MHz 32 bit ARM
INTERNAL MEMORY FLASH 2 MBYTE (LOG)
GSM QUAD BAND (850 / 900 / 1800 / 1900 MHz)
GPS SPECIFICATION
RECEIVER 22 channels
SENSITIVITY -165 dBm
FIX TIME 32 s usually
ACCURACY Up to 2.5 m

9MI005220-E MyBoat_WR
MyBoat_WR control
unit
The MyBoat-WR control unit
is a SENECA industrial-style
product (MyAlarm2). Remote
alarm, telemetry and data-
logging industrial unit.
Technical characteristics:
• Display LCD 128 x 32
Dots
• Rechargeable Li-Io bu-
er battery, up to 8 hours’
autonomy
• GSM/GPRS antenna
• Slot for mini SIM (15x25
mm)
• Internal GPS module
with integrated antenna
• ON/OFF key and display
scroll key
• Status LED: device pow-
er/status, GSM/GPRS
status
• Slot for mini SIM card
(for any rmware up-
date) and to allow the
device access to the 2G
network through the
best known SIM tele-
phone providers
2 - PRODUCT DESCRIPTION

10 MI005220-E MyBoat_WR
1 - MyBoat control unit (I1)
5 - Power supply unit 12 V
2 - Battery state sensor (I2)
8 - SD card for rmware updates
4 - User Manual
7 - Velcro to x the control unit
6 - Power cable with fork for coupling with the battery
3 - PACKET CONTENT
9 - V-SIM card by Vodafone worldwide
3 - Motor state and locker state sensor (I2)

11 MI005220-E MyBoat_WR
Power cable and battery sensor
Motor sensor
Compartment opening sensor
IPX8 terminal
Internal GPS antenna
Connection to the Seneca Cloud system
DIGITAL
INPUT
MENUON/OFF
POWER
SUPPLY
WR
TOP
BUTTONS
LOWER
PINS
4 - CONTROL UNIT OPERATION
Cable for power supply on 230 V socket
Accessory included

12 MI005220-E MyBoat_WR
The sensors are devices connected to the digital inputs of
the MyBoat-WR control unit.
Using the MyBoat By SENECA app, you can monitor the
status of the service batteries of your boat, the possible
opening of the locker compartment and the presence of
the engine.
All sensors integrate the anti-tamper function:
• I1) electric type sensor, to check the status of the ser-
vice battery.
• I2) closed contact sensor for motor tamper control and
magnetic sensor to control locker opening/closing
5 - MONITORING SENSOR DESCRIPTION

13 MI005220-E MyBoat_WR
6 - APP HOME SCREEN
Monitoring system
status
Service battery status
Motor status
1
2
3
4Locker status
5Quay connection
status
NOTIFICATION AREA
The following is displayed in the
notication area (6):
• the name of the boat being
monitored;
• the status of the boat in
comparison with the virtual
compound;
• any tampering of
a sensor in addition to the
Dedicated icon status
change
6Notication area
1
2
5
6
4
3

14 MI005220-E MyBoat_WR
7 - MYBOAT APP DESCRIPTION
1
2
3
5
4
Monitoring system
status
Perimeter alarm
status
Battery voltage status
Alarm activation but-
ton
Alarm deactivation
button
1
2
3
45

15 MI005220-E MyBoat_WR
7 - MyBoat APP DESCRIPTION
1
2
3
Indication of No. of
messages
Page management
Message preview
HISTORY FUNCTION
The history function allows display-
ing and ling the alarm messages
sent by the MyBoat system to have
a constant record of the events and
of the individual actions and/or com-
mands of all the users.
3
21

16 MI005220-E MyBoat_WR
7 - MyBoat APP DESCRIPTION
1
2
3
4
5
7
6
Close page
Conguration
of the notications
General parameters
Commands for SMS
notications
SMS address book
settings
Checks the on-board
system status
Information on the
account cloud
8Privacy settings
9Licence terms
SMS FUNCTIONS
N.B. Function available with tele-
phone SIMs allowing SMS commu-
nication.
To view these settings, activate
them in the general parameters
section.
To send and receive SMS to the
MyBoat-WR control unit, it is nec-
essary to enter the telephone
number in both the “SMS setup”
menu and in the “Address book”
section. In the latter a second
telephone number can be entered
the MyBoat control unit will send
notication SMS to.
1
2
3
4
5
6
7
8
9

17 MI005220-E MyBoat_WR
7 - MyBoat APP DESCRIPTION
1Name of the boat
3
5
Changes the icon
dimensions
Saves the modications
6Cancels the
modications
1
2
3
2SMS sending setup
4
5
4Language settings
6

18 MI005220-E MyBoat_WR
7 - MyBoat APP DESCRIPTION
1
2
Close the page
Boat 1
3Boat 2
4
5
Add boat
Cancel the operation
1
2
3
45
GENERAL SETTINGS
For the management of multiple
boats (eet), the general settings
are saved on your smartphone locally
and must be customized for a single
one-o vessel.

19 MI005220-E MyBoat_WR
7 - MyBoat APP DESCRIPTION
1
2
Close the page
Device
information
1
2

20 MI005220-E MyBoat_WR
7 - MyBoat APP DESCRIPTION
1
2
Cloud service in-
formation
Cloud service mainte-
nance
1
2