Seville Classics WEB664 User manual

Use Instrucons
 Move desk into desired posion and lock
casters to prevent movement.
 Turn the tension knob counter-clockwise to
unlock height adjustment.
 Place hands on both sides of the top and pull
up to li; press down to lower the height.
 Turn tension knob clockwise unl snug to
secure the table height.
 Pull down tabs on the T-bar to unlock lng
funcon. Press up on tabs to lock the desk.
Safety
Make sure to secure the locks when using the desk
Do not place more than 20 lbs. on the desk top
Customer Service Informaon
Telephone: [phone]
Fax: [phone]
Hours: 8:30 AM – 4:30 PM (PST)
Email: [e-mail]
Homepage: www.SevilleClassics.com
062019
STEP 4.
Pull out the tabs on MOUNT (E)
and lt the T-BAR (D) up.
Push the tabs back down to lock
the table.
STEP 5.
Fit BASE SLEEVE (I) through
boom of BASE (C). Hold in place
with HEX KEY (M).
Aach T-BAR (D) with BASE
SCREW (K) using second HEX KEY
(M). Repeat for all base screws.
STEP 6.
Aach SIDE TABLE (B) to
T-BAR (D) with SIDE TABLE
SCREW (J) using HEX KEY (M).
Make sure all screws are ght
and turn desk onto wheels.
Congratulaons! Enjoy your new
Mobile Desk Cart!
Tilng Sit-Stand Mobile Desk Cart
with Mouse Pad Table
062019
Model: WEB664, OFF65993B
Thank you for choosing Seville Classics! We hope that you enjoy your new
mobile desk cart. Please read through this user guide for parts list, assembly
instrucons, frequently asked quesons and contact informaon.

Parts List
A. Main table (1)
Please make sure you have all the parts on this list.
If you’re missing parts, contact us for replacements at
[phone] or send an email to [e-mail]
1
B. Side table (1)
C. Base (1)
D. T-Bar (1)
E. Mount (1)
F. Small cap (2)
G. Locking caster (2)
H. Caster (2)
I. Base sleeve (4)
J. Side table screw (2)
K. Base screw (4)
L. Knob (1)
M. Hex key (2)
N. Wrench (1)
O. Top screw (6)
2
STEP 1.
Screw pair of CASTERS (H) into open
side of BASE (C) using WRENCH (N).
Repeat on opposite side with
LOCKING CASTERS (G).
Press SMALL CAPS (F) into ends of
T-BAR (D).
Tighten KNOB (L) against t-bar.
STEP 2.
Install MOUNT (E) to the base of
MAIN TABLE (A) with TOP SCREWS
(O) using HEX KEY (M).
IMPORTANT!
Do not overghten screws.
Overghtening screws may
damage surface of table top.
STEP 3.
Install T-BAR (D) to MOUNT (E) with
TOP SCREWS (O) using HEX KEY (M).
Assembly Instrucons
[email protected]
1 [phone]