Seville Classics WEB247 User manual

10 Slot
Literature Organizer
WEB247
Assembly Instructions
Customer Service
Toll free: 800-323-5565
Monday through Friday 8:30 AM – 4:30 PM (PST)
Torrance, CA 90501 USA
www.sevilleclassics.com
READ AND SAVE THESE INSTRUCTIONS

#WEB247
A1 piece
Base Panel BC
1 piece 1 piece D E
4 pieces
Side Panel
Center Panel Grid Shelves Side Panel 1 piece
F1 piece
Top Panel G H
2 pieces
2 pieces
IJ
6 piecesBack Panel
Cross Bar Support
Screws Feet 6 pieces
Place the Base Panel (A) on a secure flat surface with
the grid pattern wires on top running front to back.
Place Side Panel
(B) vertical onto the two upright posts
on the right side of Base Panel (A). Make sure the “L”
shaped shelf supports are facing inwards.
Place the Center Panel (C) vertical onto the two
upright posts in the center of Base Panel (A).
NOTE: The screws holes should be facing the back.
12 - Slot Literature Organizer Assembly lnstruction
STEP 1
STEP 2
1010 - Slot Literature Organizer Assembly lnstruction

Place the Top Panel (F) onto the three vertical
support Panels (B, C, E) so that the posts on (F)
slide into all 6 of the upright support holes.
STEP 5
Place Side Panel (E) vertical onto the two upright
posts on the left side of Base Panel (A), making sure
the wire Grid Shelves (D) sit on the inward facing “L”
shaped shelf supports of Side Panel (E).
NOTE: The screws holes should be facing the back.
STEP 4
Slide all 4 wire Grid Shelves (D) with the grid pattern
wires on top running front to back, through the slots
in Center Panel (C) and onto the “L” shaped shelf
supports of Side Panel (B).
STEP 3
STEP 6
Place the Back Panels (G), one right and one left, on the back
side of the organizer (the side with the screw holes). Each
Back Panel (G) has two hooks that should be placed over the
back edge wire on the Top Panel (F). Furthermore, the
bottom of the Back Panels (G) have two “S” shaped hooks
that spring into placed on the wire of Base Panel (A).
Simply push on Back Panel (G) and it will “snap” into place.

TF141015
STEP 7
STEP 8
STACKING
On the back of the organizer, place Cross Bar Supports (H) across the
three vertical panels (B, C, E) and use Screws (I) to secure them in
place. NOTE: The Cross Bar Supports (H) were designed to partially
wrap around the vertical supports for a secure fit. Make sure the bar
faces the vertical supports properly.
Turn the assembled organizer unit upside down and slide each of the
6 Feet (J) on the Base Panel (A) posts.
1) Assemble the second Organizer, but do not attach the Feet (J).
2) Remove the Top Panel (F) from the first Organizer (the unit to
be placed on the bottom).
3) Carefully lift and place the second Organizer over and onto the
three vertical supports (B, C, E) of the bottom unit making sure the
posts on Base Panel (A) of the top unit slide into all 6 of the vertical
support holes of the bottom unit.