Seville Classics FRN04742 User manual

Step 2: Refer to the picture below. First, tighten the 6 pre-inserted Long Screws
(marked “A” in the picture). Next, screw in and tighten the 6 Short Screws (B) into the
6 screw holes on the unit (these screw holes are marked “B” in the picture). Do NOT
over tighten the screws.
How to Fold the Tower (If Needed): First, fully loosen and remove all 6 Short Screws
(marked “B” in the picture above) from the unit. Next, fully loosen (about 5 turns), but
do NOT remove, the 6 remaining pre-inserted Long Screws (marked “A” in the picture
above). Finally, carefully fold down the unit. Please note that the unit CANNOT be
folded completely flat. Forcing the unit into a folded position without first removing the
6 Short Screws (B) and fully loosening the 6 pre-inserted Long Screws (A) may result
in irreparable damage to the unit.
4
Resin 3-Tier Tower
Model No. FRN04742
ASSEMBLY INSTRUCTIONS
CustomerService
Tel1.800.323.5565
Fax1.310.533.3899
MondaythroughFriday8:30AM‐4:30PM(PST)

SevilleClassics,Inc.
Torrance,CA90501USA
www.sevilleclassics.com

READANDSAVETHESEINSTRUCTIONS
CAUTION
1) Do NOT over tighten the screws. Doing so may damage the unit.
2) Do NOT place the unit in high temperature area or near appliances that emit large
amount of heat.
3) Do NOT place the unit in direct sunlight as it may cause the color to fade.
4) Do NOT place the unit on uneven surfaces. Doing so may cause the unit to tip over.
5) Examine the screws periodically and tighten them if they are loose.
6) Weight capacity: 75 lb per shelf
7) Check unit to ensure that it is level before use.
PARTS LIST
Please check the parts you received according to the parts list below.
(A) (B)
Folded 3-Tier Tower (1 pc) (A) Long Screw (6 pcs)
pre-inserted in the unit
(B) Short Screw (6 pcs)
*Tool needed: Phillips Screwdriver and Level
2
Please Note:
1) Do NOT place the unit vertically when unfolding as this may result in the unit
suddenly unfolding and pinching your fingers.
2) Find a flat surface or floor to assemble the unit. Using an uneven surface or floor to
assemble the unit may result in uneven/unlevel shelves, which can compromise
strength of the unit.
3) Check unit before using to ensure it is level.
3) If the unit is uneven/unlevel after assembled, loosen both screws (A & B), adjust the
unit and then retighten the screw (A & B).
ASSEMBLY INSTRUCTIONS
Step 1: Use a Phillips screwdriver to loosen the 6 Long Screws (A) that have already
been pre-inserted in the unit. Do NOT remove the screws from the unit. Simply
loosen them to allow the unit to unfold. Next, place the compressed unit horizontally
and position your hands to carefully unfold the unit.
3