Seville Classics airLift OFF65921 User manual

Overbed Height Adjustable Mobile
Side Table Cart
112020
Models: OFF65921/9
Please contact Seville Classics for help with assembly and
to report any damaged or missing components.
Phone: [phone]
Email: [e-mail]
Homepage: www.SevilleClassics.com

Parts List
Please make sure you have all the parts on this list.
If you’re missing parts, contact us for replacements at
[phone] or send an email to [e-mail]
1
A. Base (1)
B. Neck (1)
C. Top frames (2)
D. Top (1)
E. Casters (2)
F. Locking casters (2)
G. Large wrench (1)
H. Caps (4)
I. Long screw (4)
J. Medium screw (4)
K. Short screw (4)
L. Washers (4)
M. Nuts (4)
N. Split washers (4)
O. Knob (1)
P. Small wrench (1)
Q. Hex key (1)

STEP 1.
Aach pair of LOCKING CASTERS (F) to
wide end of the BASE (A) using
LARGE WRENCH (G).
Aach pair of CASTERS (E) to other side
of the BASE (A) the same way.
STEP 2.
Place SPLIT WASHERS (N) over holes on
top of BASE (A).
Align holes on boom of NECK (B) with
split washers and holes on base.
Fit MEDIUM SCREWS (J) through the
boom of neck, split washers and base.
Hold MEDIUM SCREWS (J) with the
HEX KEY (Q) and fasten with NUTS (M)
using SMALL WRENCH (P).
Tighten unl snug.
Screw KNOB (O) into side of NECK (B).
STEP 3.
Press CAPS (H) into open ends of both
TOP FRAMES (C).
Align holes of one TOP FRAME (C) with
holes on side of NECK (B). Aach with
LONG SCREWS (I).
Repeat for other TOP FRAME (C).
Tighten with HEX KEY (Q) unl snug.
Contact Us!
[e-mail]
1 [phone]

Customer Service Informaon
Telephone: [phone]
Fax: [phone]
Hours: 8:30 AM – 4:30 PM (PST)
Email: Suppor[email protected]
Homepage: www.SevilleClassics.com
112020
Use Instrucons
 Move desk into desired posion and lock the front casters.
 Turn the tension knob counter-clockwise to unlock height adjustment.
 Place hands on both sides of the top and pull up to li; press down to lower the height.
 Turn tension knob clockwise unl snug to secure the table height.
Safety
DO NOT put more than 15 lbs. (evenly distributed) on the desk top.
Remove items from desktop when adjusng height.
STEP 4.
Carefully place TOP (D) onto the TOP FRAMES (C)
and line up the screw holes.
Fit WASHERS (L) over the SHORT SCREWS (K).
Aach screws to TOP (D) through boom of
TOP FRAMES (C) and ghten with HEX KEY (Q).
Congratulaons!
Enjoy your new Overbed
Laptop Desk Cart!