Seville Classics UltraHD 20209 User manual

SC200820
ASSEMBLY INSTRUCTIONS
UltraHD® Wall Cabinet (Model No. 20209, 20149)
24 in. W x 12 in. D x 28 in. H
60.96 cm W x 30.47 cm D x 71.12 cm H
Granite Graphite
Reference page 9 for special care and
maintenance of stainless steel

For Door Handle on LEFT Side
For Door Handle on RIGHT Side
#8
#55
#5
#4
#3
#23#2
#7
#41
#15
#34
#6
#2
#1
#1
#2
#6
#23
#34
#41
#7 #2 #15
#3
#4
#5
#55
#8
1

PARTS LIST
Please check the parts carefully according to the parts list. If you are missing any parts, please contact our
customer service department (please refer to page 9).
(#3) RIGHT PANEL x 1 PC
(#4) UPPER BACK PANEL x 1 PC
(#1) LEFT PANEL x 1 PC
(#2) TOP / BOTTOM PANEL (Both panels are same) x 2 PCS
(#5) BOTTOM BACK PANEL x 1 PC
(#6) MIDDLE SHELF x 1 PC
(#7) LEFT / RIGHT DOOR x 1 PC
(#8) WALL-HANGING BRACKET x 2 PCS
2

(#34) HOOK x 4 PCS
(#41) SCREW F (M4 x 8L) x 32 PCS
(#55) SCREW M (M6 x 50L) x 8 PCS
(#15) SCREW B (M4 x 8L) x 9 PCS
PARTS LIST
Please check the parts carefully according to the parts list. If you are missing any parts, please contact our
customer service department (please refer to page 9).
(#23) MAGNET x 2 PCS
(#21-A) SCREW DRIVER x 1 PC
(#22) KEY x 2 PCS
3

TIP:
Step 1:
a.
b.
Step 2: Install Bottom Panel (#2).
TIP: A magnetic screwdriver is included for
convenience. If using a power screwdriver, keep
torque setting LOW.
Attach the Left Panel (#1) to the Top Panel (#2)
as the left picture shows. Line up screw holes
and tighten them using Screwdriver (#21-A) and
Screw F (#41).
Attach Bottom Panel (#2) between the
Left Panel (#1) and Right Panel (#3) as the
left side picture shows. Line up screw holes
and tighten them using Screwdriver (#21-A)
and Screw F (#41).
Install the Left Panel (#1) onto the Top Panel (#2)
the same way.
Install the Right Panel (#3) onto the Top Panel (#2).
Attach the Right Panel (#3) to the Top Panel (#2)
as the left picture shows. Line up screw holes and
tighten them using Screw Driver (#21-A) and
Screw F (#41).
#3#41 #21-A #2
Front
Back
#2
Front
Back
#41
#1
#2#41
4
UltraHD® Wall Cabinet (Model No. 20209)
*NOTE: We recommend TWO people to assemble the cabinet.

Step 3:
Step 4:Fasten the Magnet (#23).
Note: Decide the door's opening direction.
Step 5:Install the Middle shelf (#6).
Note:
Install the Bottom Back Panel (#5) and Upper
Back Panel (#4).
The Middle Shelf (#6) needs the 4 hooks at each
corner for support. When placing the hooks, make
sure they are at the same height.
b. Place the Middle Shelf (#6) into the cabinet and
push down onto the Hooks (#34).
Purchase additional shelves
(Model #: UHD20209S) on SevilleClassics.com.
First place the Bottom Back Panel (#5) onto the
Left Panel (#1), Right Panel (#3) and Bottom Panel
(#2) as the left picture shows. Now place the
Upper Back Panel (#4) onto the Left Panel (#1),
Right Panel (#3) and Top Panel (#2). Line up screw
holes and tighten them using Screwdriver (#21-A)
and Screw F (#41).
a. Decide the height for the Middle Shelf (#6),
place the Hooks (#34) into the hook slots and
push down.
(1)
Stand up the cabinet like the left diagram (1)
shows to have the door hinge on the right.
Fasten Magnet (#23) to the Left Panel (#1) using
Screwdriver (#21-A) and Screw B (#15).
Stand up the cabinet like the right diagram (2)
shows to have the door hinge on the left.
Fasten Magnet (#23) to the Right Panel (#3) using
Screwdriver (#21-A) and Screw B (#15).
(2)
#4
#5
#41Top
Bottom
#23
#15
#3
#23
#15
#1
#6
#34
#1
#3
5
UltraHD® Wall Cabinet (Model No. 20209)
*NOTE: We recommend TWO people to assemble the cabinet.

Step 6:Install the Door (#7)
(1)
(2)
Step 7:
(1)
(2)
Attach the Door (#7) to the unit. Line up screw
holes and tighten them using Screwdriver (#21-A)
and Screw B (#15).
Complete Assembled Cabinet.
a. Left Side Door (1)
b. Right Side Door (2)
#7
#15
#15#7
6
UltraHD® Wall Cabinet (Model No. 20209)
*NOTE: We recommend TWO people to assemble the cabinet.

C. Locate the 2nd stud 16" from either side of the 1st stud location.
Note: The distance between two studs is normally 16" (center to center).
A. Decide where to hang the Wall Cabinet.
B. Start from one side of desired location to find the 1st stud location for installing the Wall-Hanging Brackets (#8). Use a
stud finder to locate the stud and use a pencil to mark the center of the stud.
Use the Installation Guide on pages 7 and 8 to secure the two Wall-Hanging Brackets (#8) to the wall. Lift the wall cabinet
up and hook its tongues (located on the back panels) over the Wall-Hanging Brackets. Assure all tongues hook securely over
both Wall-Hanging Brackets. Please refer to the pictures on pages 8 and 9.
Installation Guide for the WALL-HANGING BRACKET
of the UltraHD Wall Cabinet (Model No. 20209)
Note: We recommend that the cabinet be hung such that the bottom of the cabinet rests approx. 63" above the floor.
Recommended Height
from Floor
63"
FLOOR
DOOR
??
63" 63"
#8
#8
7
UltraHD® Wall Cabinet (Model No. 20209)
*NOTE: We recommend TWO people to assemble the cabinet.

E. Use Screw M (#55) to fasten Wall-Hanging Brackets (#8).
Hang the unit on the Wall-Hanging Brackets (#8) as following pictures show.
Note: The shop drawing shows the actual size of the Wall Cabinet (28" by 24")
and indicates the locations of the holes on the Wall-Hanging Brackets.
You may also want to temporarily tape the drawing to the wall for marking the
locations of the screws. Use a small nail to penetrate the shop drawing and
mark the eight points to fasten the Wall-Hanging Bracket.
After marking locations, pre-drill a small hole (1/4" diameter) at each of the
eight hole locations.
UltraHD® Wall Cabinet (Model No. 20209)
*NOTE: We recommend TWO people to assemble the cabinet.
*Drill a small hole (1/4" diameter) at both stud locations to ensure that
the hanging anchor is secured.
D. To find the rest of the screw holes to fasten the Wall-Hanging Brackets,
please refer to the accompanying shop drawing. Place the shop drawing
on the wall, and align the holes in the drawing with those already drilled in
the wall.
Hang Wall Cabinet Wall-Hanging
Brackets
16"
#55
8

UltraHD® Wall Cabinet (Model No. 20209)
将
左
UltraHD® Stainless Steel Care Instructions
• Lightly wipe with warm water and clean microfiber cloth
• Always wipe in the direction of the surface grain (NEVER ACROSS)
• Wipe away excess water with dry clean cloth
The stainless-steel parts of this product are protected with an UltraGuard® fingerprint resistant finish.
DO NOT use traditional stainless-steel cleaners. To safely manage unwanted fingerprints and prevent new
stains, perform the following steps once monthly:
Back Panel View of Wall Cabinet shows 6 flat hooks that
allow the Cabinet to hang on two Wall-Hanging Brackets.
Close-up view of how the Wall-Hanging Brackets fit with
the 6 flat hooks on the back of the cabinet.
9
Installing Additional Shelves
Step 1: Follow the previous instructions to Step 5.
Install additional shelves (UHD20209S)
the same way.
Installing Additional Shelves (UHD20209S)*
*Sold separately on SevilleClassics.com.
UltraHD® Wall Cabinet (Model No. 20209)
*NOTE: We recommend TWO people to assemble the cabinet.

Seville Classics, Inc.
19401 Harborgate Way Torrance, CA 90501 USA
Telephone: [phone] within USA
Fax: [phone]
Hours: 9:00am - 4:30pm (Pacific Standard Time)
E-mail: [e-mail]
Website & Online Store: www.sevilleclassics.com
UltraHD® Tall Storage Cabinet UltraHD® Mega Storage Cabinet
Model No. 16236 (Granite) Model No. 16238 (Granite)
Model No. 20143 (Graphite) Model No. 20148 (Graphite)
Model No. 20153 (Red) Model No. 20158 (Red)
Model No. 20133 (White)
CONTACT INFORMATION
UltraHD® Wall Cabinet (Model No. 20209)
bilingual (English and Spanish) customer service department at:
***Please visit our website or call and inquire about our additional UltraHD Line***
UltraHD® Line
10

UltraHD® 4-Drawer Rolling Cabinet UltraHD® 6-Foot Height Adjustable Workbench
Model No. 20205 (Granite) Model No. 20292 (Granite)
UltraHD® Wall Cabinet with Open Shelf UltraHD® 2-Door Rolling Workbench
Model No. 20230 (Granite) Model No. 20262 (Granite)
Model No. 20140 (Graphite) Model No. 20142 (Graphite)
Model No. 20150 (Red) Model No. 20152 (Red)
UltraHD® Rolling Trash Bin UltraHD® Lighted Workcenter
Model No. 20215 Model No. 20247 (Granite)
Model No. 20246 (Graphite)
Model No. 20157 (Red)
UltraHD® Line