Seville Classics WEB714 User manual

2-TIER SHOE / STORAGE RACK
122021 122021
Model: WEB714
Thank you for choosing Seville Classics. We hope that you enjo y your
new 2-tier shoe rack. Please contact our Customer Support for any
questions (see back page for contact information). Thank you.
4 Units - 3 Configuration Options
WARNING : Do not stand on or climb on the shelving system. Do not
drop heavy items on the system. Place heavier items on the lower
shelves and lighter ones on the top shelves. Do not move the system
while loaded.
Dimensions: 26.6" W x 12.2" D x 12.6" H
Weight capacity top: 50 lbs. (25 lb. per shelf, evenly distributed)

1
Please make sure you have all the parts on this list.
If you're missing parts, contact us for replacements at
[phone] or send an email to [email protected]
2
A
Rack (x1)
B
Leveling Foot (x4) Cap (x4) Shelf (x2) Stacking Pin (x4)
ASSEMBLING THE RACK
1.. Unpack and emove all parts from the box. If there
are missing or broken parts, please contact CUSTOMER
SERVICE.
2.. crew the LEVELING FEET (B) into the bottoms of
each leg of the RACK (A).
3.. nsert the CAPS (C) into the holes on the top of the
rack. Note: if you want to stack two units, skip this step
as these holes will be used by the STACKING PINS (E).
4.. lace the unit upright, with the feet on the oor.
Unfold it.
5.. Slide a SHELF ) in at an angle (see diagram) then
rotate it to the correct position and press down rmly
on each bracket, making sure that they snap into place.
Note: if the shelf does not snap in easily, simply adjust
the plastic clip within the bracket by aligning the
plastic nub into the bracket window.
6.. Repeat ep 5 for the other shelf. Once all shelves are
rmly in place, adjust the leveling feet by screwing
them in or out to obtain a level unit.
STACKING THE RACK
1.. Build another rack ollowing the instructions above.
However, do not install the LEVELING FEET (B) on the
second (top) unit.
2.. crew the STACKING PINS (E) into the bottoms of
each leg of the top unit.
3.. Re ve all CAPS (C) from the original (base) unit.
4.. L t the top unit up and onto the base unit, lining up
the pins with the holes at the four top corners so that
they can be inserted into each other.
5.. Be s e everything is in alignment and then press
down rmly on the top unit so that it ts tightly into
and onto the base unit.
2 Units - 3 Configuration Options
3 Units - 3 Configuration Options
Connect by attaching the shelves to any
side bar of one unit to the corresponding
side bar of another unit.
NOTE: Illustration shows 2 shelving
units stacked vertically. Do not exceed
maximum height of 2 stacked units.