Sharp MX3050 User manual

Step 1. Open the
front cover of your
machine.
Slit glass cleaning wand
Charge cleaner wand
Step 2: Remove waste
container
Press in green tabs on both ends of
the waste container to release.
Pop out and carefully remove waste
container from machine

Step 3: Locate black scker with green tri-
angles. Insert gray cleaning wand, foam pad
side facing down, into the hole directly
above the black scker. Carefully push gray
wand back as far as it will go (It will not go
back the enre length of the wand). Run
the cleaner front to back a few mes. Re-
peat for each color- (Y, M, C, B)
For void areas on prints and copies
follow Step 3.
• For lines on prints and copies,
skip to Step 4.

Step 4: Locate green scker with
black triangle. Insert green cleaning
wand, roller side facing up, into the
hole below the green scker. (Black
triangle on the end of the green wand
will be facing upright). Carefully push
green wand back as far as it will go (It
will no go back the enre length of the
wand). Run the cleaner front to back a
few mes. Repeat for each color- (Y,
M, C, B)

For lines on scans and copies :
• Li lid of document feeder
Using a cloth/paper towel and Windex or denatured
alcohol, clean both the copy glass and the slit glass.
Lines on copies and scans could be caused by small
marks or even a hair on the glass.
- Note: Do not spray cleaner directly on glass. Spray cleaner on
cloth/paper towel, then wipe the glass