Shure PA805Z2-RSMA User manual

IMPORTANT SAFETY INSTRUCTIONS
1. READ these instructions.
2. KEEP these instructions.
3. HEED all warnings.
4. FOLLOW all instructions.
5. DO NOT use this apparatus near water.
6. CLEAN ONLY with dry cloth.
7. DO NOT block any ventilation openings. Allow sufficient distances for
adequate ventilation and install in accordance with the manufacturer’s
instructions.
8. DO NOT install near any heat sources such as open flames, radiators,
heat registers, stoves, or other apparatus (including amplifiers) that pro-
duce heat. Do not place any open flame sources on the product.
9. DO NOT defeat the safety purpose of the polarized or grounding type
plug. A polarized plug has two blades with one wider than the other. A
grounding type plug has two blades and a third grounding prong. The
wider blade or the third prong are provided for your safety. If the provided
plug does not fit into your outlet, consult an electrician for replacement
of the obsolete outlet.
10. PROTECT the power cord from being walked on or pinched, particularly
at plugs, convenience receptacles, and the point where they exit from
the apparatus.
11. ONLY USE attachments/accessories specified by the manufacturer.
12. USE only with a cart, stand, tripod, bracket, or table specified by the
manufacturer, or sold with the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to avoid injury from tip-over.
13. UNPLUG this apparatus during lightning storms or when unused for long
periods of time.
14. REFER all servicing to qualified service personnel. Servicing is required
when the apparatus has been damaged in any way, such as power
supply cord or plug is damaged, liquid has been spilled or objects have
fallen into the apparatus, the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropped.
15. DO NOT expose the apparatus to dripping and splashing. DO NOT put
objects filled with liquids, such as vases, on the apparatus.
16. The MAINS plug or an appliance coupler shall remain readily operable.
17. The airborne noise of the Apparatus does not exceed 70dB (A).
18. Apparatus with CLASS I construction shall be connected to a MAINS
socket outlet with a protective earthing connection.
19. To reduce the risk of fire or electric shock, do not expose this apparatus
to rain or moisture.
20. Do not attempt to modify this product. Doing so could result in personal
injury and/or product failure.
21. Operate this product within its specified operating temperature range.
Explanation of Symbols
Caution: risk of electric shock
Caution: risk of danger (See note.)
Direct current
Alternating current
On (Supply)
Equipment protected throughout by DOUBLE INSULATION or
REINFORCED INSULATION
Stand-by
Equipment should not be disposed of in the normal waste stream
WARNING: Voltages in this equipment are hazardous to life. No user-ser-
viceable parts inside. Refer all servicing to qualified service personnel. The
safety certifications do not apply when the operating voltage is changed from
the factory setting.
WARNING:This product contains a chemical known to the State of California
to cause cancer and birth defects or other reproductive harm.
General Description
The Shure PA805Z2-RSMA is a passive directional antenna that improves
RF performance by rejecting off-axis RF signal. Positioned remotely, antennas
can be aimed directly at transmitters.
The antenna attaches to a microphone stand or to the separate wall-mounting
bracket, and delivers the following benefits over standard omnidirectional
half-wave antennas:
• Reduced interference
• Improved RF signal-to-noise ratio
• Antenna gain (8 dBi) helps overcome cable loss
Installation Instructions
1. Determine the length of cable required to connect each antenna to the receiver or antenna/power distribution system. Use the shortest length of cable pos-
sible, because longer cable runs increase power and signal loss.
Important: Only use low-loss reverse SMA cables to prevent signal loss.
2. Use reverse SMA cables to connect an antenna to each of the ANTENNA A and ANTENNA B ports of the receiver or antenna/power distribution system.
1/4©2016 Shure Incorporated
PA805Z2-RSMA
Passive Directional Antenna

3. Position antennas so there is nothing obstructing the line of sight to the transmitter, including the audience. Point antennas at the transmitters, with the rear
side facing sources of interference (Wi-Fi access points, for example). Placing them farther apart improves diversity performance. For optimal performance,
minimize the distance between the transmitters and the antennas by placing antennas near the stage, rather than at a front-of-house position.
Note: Always perform a walk-around test to verify coverage before using a wireless system during a speech or performance. Experiment with antenna placement
to find the optimum location. If necessary, mark any trouble spots and ask presenters or performers to avoid those areas.
power
mic
instr / aux
line
FW update
antenna Bantenna A
GLXD4R
Cable Selection
Loss at 2.4 GHzTypeLengthCable
1 dBReverse SMA0.6 m (2 ft.)UA802-RSMA
1dB
Reverse SMA1.8 m (6 ft.)UA806-RSMA
1.5 dB
Reverse SMA3 m (10 ft.)95C31342
3.3 dB
Reverse SMA7.6 m (25 ft.)UA825-RSMA
Loss at 2.4 GHzTypeLengthCable
6.4 dB
Reverse SMA15.2 m (50 ft.)UA850-RSMA
6.8 dB
Reverse SMA30.4 m (100 ft.)UA8100-RSMA
For additional technical assistance, call the Shure Customer Service Depart-
ment.
Furnished Accessories
95C313423 m (10 ft.) Reverse SMA Cable (1)
31B1856Brass Adapter
Optional Accessories and Replacement Parts
Shure IncorporatedPA805Z2-RSMA Passive Directional Antenna
2017/06/092/4

UA505-RSMARemote Antenna Mounting Bracket Kit
UA846Z2Frequency manager (antenna/power distribution sys-
tem)
UA221-RSMAReverse SMA Passive Antenna Splitter (900 MHz ISM,
DECT, 2.4 GHz)
UA802-RSMA0.6 m (2 ft.) Reverse SMA Cable
UA806-RSMA1.8 m (6 ft.) Reverse SMA Cable
95C313423 m (10 ft.) Reverse SMA Cable
UA825-RSMA7.6 m (25 ft.) Reverse SMA Cable
UA850-RSMA15.2 m (50 ft.) Reverse SMA Cable
UA8100-RSMA30.4 m (100 ft.) Reverse SMA Cable
95A32436Reverse SMA Bulkhead Adapters, lockwasher, nut
Specifications
Frequency Range
<2:1 Voltage Standing Wave Ratio (VSWR)
2050 to 2700 MHz
Antenna Gain
@ 2.45 GHz, typical
8 dBi
3 dB Horizontal Beam Width
100 degrees
Efficiency
@2.45 GHz, typical
89 %
Impedance
50 Ω
Polarization
Linear
Front-to-back ratio
@ 2.45 GHz, typical
24 dB
Connector Type
Reverse SMA
Dimensions
105 x 164 x 27.5 mm H x W x D
Net Weight
2.5 oz.
Shure IncorporatedPA805Z2-RSMA Passive Directional Antenna
3/42017/06/09

2.05 GHz
2.65 GHz
2.45 GHz
2.25 GHz
Polar Pattern
Certifications
This product meets the Essential Requirements of all relevant European di-
rectives and is eligible for CE marking.
The CE Declaration of Conformity can be obtained from:
www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: [phone]
Fax: [phone]
Email: [email protected]
Shure IncorporatedPA805Z2-RSMA Passive Directional Antenna
4/4
Shure Incorporated 5800 West Touhy Avenue Niles, IL 60714-4608 USA Phone:[phone] Email: [email protected]