Siemens SPD4tel User manual

s
SPD4tel & SPD4telkit
User Manual
Manuel d’ Installation

Table of Contents
User Manual - USA English ...........................................1
User Manual - Canada English / Anglais ........................5
Manuel d’installation - Canada Français / French ...........7
s

s
USA
www.usa.siemens.com/spd

1
▪UL listed
▪Hardwired Modem/Fax/DSL protection
▪Easy to install
▪Exceptionally fast response time
▪Low insertion loss
▪Available with or without enclosure
▪5-Year product warranty*
The Siemens SPD4tel is a 2 pair, hardwired surge protector for telephone, DSL or modem
connected electronics in residential and light commercial applications. The SPD4tel
protects against electrical power surges that can enter through the main telephone
connection and is equipped with a failshort device to permanently ground the telephone
line in the event of a power cross. The SPD4tel is designed for indoor applications or can
be mounted inside another weatherproof enclosure for outdoor mounting applications.
The SPD4telkit includes the SPD4tel plus a weatherproof enclosure to facilitate indoor
or outdoor applications. The enclosure is molded of temperature and humidity resistant
thermoplastic to resist cracking and discoloration. The cover can be secured with a tie
wrap or similar locking device.
For total home protection please use SPD4home to protect your incoming AC Power lines
and SPD4coax to protect your coaxial connections.
Total Home Surge Protection
SPD4tel & SPD4telkit
Surge Protection for Telephone or
Modem Connected Electronics
Features and Benefits
User Manual - USA
English
Technical Specifications
AC SURGE PROTECTION
Catastrophic Surge Circuit Yes
Spike Capacity 200 Amps
Let Through Voltage <270 V
Overcurrent Protection Yes
Response Time <1 nanosecond
Environmentally Sealed Yes
AGENCY APPROVALS & WARRANTY
UL/cUL Listings 497A
Meets Telcordia (formallly Bellcore) GR-974-CORE
Requirements for Telecommunications Line Protectors Yes
Product Warranty 5 Years
CATALOG NUMBER
SPD4tel 2 pair protection module
SPD4telkit 2 pair protection module 1 Weatherproof Enclosure
UL Model No. - SATH2
* See www.usa.siemens.com/spd for warranty details.

2
DO NOT INSTALL DURING ACTIVE
STORM CONDITIONS.
This device can be used indoor (SPD4tel),
or outdoor when installed in weatherproof
housing(SPD4telkit). Failure to follow
installation instructions can result in personal
injury and/or equipment damage not covered
by warranty.
SPD4tel – For indoor use:
▪SPD4tel protects 2 pairs (1 pair per
protector module) and is intended for
indoor use only, without additional
housing.
▪Attach securely to mounting surface.
▪Install ground wire, and if applicable,
service shield, under top center nut
of mounting bracket and tighten nut
securely.
▪Connect one pair (tip and ring) under
the bottom nut on each protector
module, tip on one post, ring on the
other.
▪Connect the customer wiring, tip and
ring, under the top nut on the same
protector module (protector is wired in
parallel)
▪Check all wiring for loose connections
and shorting or broken wires.
SPD4telkit – For outdoor use:
▪Mount weatherproof housing securely
to flat surface.
▪Conductors will enter and exit from the
flexible grommet located at bottom of
enclosure.
▪Follow instruction above for SPD4tel
connections.
▪Secure enclosure with tie wrap or
similar locking device.
▪The SPD4telkit is a Parallel Device.
Installation Instructions:
User Manual -USA
Siemens Industry, Inc.
5400 Triangle Parkway
Norcross, GA 30092
888-333-3545
[email protected]
©2010 Siemens Industry, Inc.
All Rights Reserved. Siemens is a registered
trademark of Siemens AG. Product names
mentioned may be trademarks or registered
trademarks of their respective companies.
Specifications are subject to change without notice.
www.usa.siemens.com/spd
Telco Side Cable
Terminate Between
Washers
Ground Clip
Customer Side
Cable
Terminate Between
washers

s
Canada
www.purgethesurge.ca

5
User Manual - Canada
English / Anglais
▪cUL listed
▪Hardwired Modem/Fax/DSL protection
▪Easy to install
▪Exceptionally fast response time
▪Low insertion loss
▪Available with or without enclosure
▪5-Year product warranty*
The Siemens SPD4tel is a 2 pair, hardwired surge protector for telephone, DSL or modem
connected electronics in residential and light commercial applications. The SPD4tel
protects against electrical power surges that can enter through the main telephone
connection and is equipped with a failshort device to permanently ground the telephone
line in the event of a power cross. The SPD4tel is designed for indoor applications or can
be mounted inside another weatherproof enclosure for outdoor mounting applications.
The SPD4telkit includes the SPD4tel plus a weatherproof enclosure to facilitate indoor
or outdoor applications. The enclosure is molded of temperature and humidity resistant
thermoplastic to resist cracking and discoloration. The cover can be secured with a tie
wrap or similar locking device.
For total home protection please use SPD4home to protect your incoming AC Power lines
and SPD4coax to protect your coaxial connections.
Total Home Surge Protection
SPD4tel & SPD4telkit
Surge Protection for Telephone or
Modem Connected Electronics
Features and Benefits
Technical Specifications
AC SURGE PROTECTION
Catastrophic Surge Circuit Yes
Spike Capacity 200 Amps
Let Through Voltage <270 V
Overcurrent Protection Yes
Response Time <1 nanosecond
Environmentally Sealed Yes
AGENCY APPROVALS & WARRANTY
UL/cUL Listings 497A
Meets Telcordia (formallly Bellcore) GR-974-CORE
Requirements for Telecommunications Line Protectors Yes
Product Warranty 5 Years
CATALOG NUMBER
SPD4tel 2 pair protection module
SPD4telkit 2 pair protection module 1 Weatherproof Enclosure
UL Model No. - SATH2
* See www.purgethesurge.ca for warranty details.

6
User Manual - Canada
DO NOT INSTALL DURING ACTIVE
STORM CONDITIONS.
This device can be used indoor (SPD4tel),
or outdoor when installed in weatherproof
housing(SPD4telkit). Failure to follow
installation instructions can result in personal
injury and/or equipment damage not covered
by warranty.
SPD4tel – For indoor use:
▪SPD4tel protects 2 pairs (1 pair per
protector module) and is intended for
indoor use only, without additional
housing.
▪Attach securely to mounting surface.
▪Install ground wire, and if applicable,
service shield, under top center nut
of mounting bracket and tighten nut
securely.
▪Connect one pair (tip and ring) under
the bottom nut on each protector
module, tip on one post, ring on the
other.
▪Connect the customer wiring, tip and
ring, under the top nut on the same
protector module (protector is wired in
parallel)
▪Check all wiring for loose connections
and shorting or broken wires.
SPD4telkit – For outdoor use:
▪Mount weatherproof housing securely
to flat surface.
▪Conductors will enter and exit from the
flexible grommet located at bottom of
enclosure.
▪Follow instruction above for SPD4tel
connections.
▪Secure enclosure with tie wrap or
similar locking device.
▪The SPD4telkit is a Parallel Device.
Installation Instructions:
Telco Side Cable
Terminate Between
Washers
Ground Clip
Customer Side
Cable
Terminate Between
washers

7
▪Homologation cUL
▪Protection câblée pour modem/télécopieur/ligne numérique
▪Facile à installer
▪Temps de réponse exceptionnellement rapide
▪Affaiblissement d’insertion peu important
▪Avec ou sans boîtier
▪Produit garanti 5 ans*
Le suppresseur de surtensions SPD4tel câblé à deux paires de Siemens est destiné à
la protection d’appareillages électroniques pour la maison et les petites applications
commerciales connectés par téléphone, ligne numérique ou modem. Le SPD4tel protège
contre les surtensions qui peuvent provenir du raccordement téléphonique principal. Il
comporte une sécurité intégrée qui met à la terre en permanence la ligne téléphonique,
en cas d’inversion de polarité. Conçu pour les applications intérieures, le SPD4tel peut
aussi être installé à l’extérieur, dans un boîtier étanche.
L’ensemble SPD4telkit comprend le suppresseur de surtensions SPD4tel et un
boîtier étanche, afin de faciliter l’installation à l’intérieur comme à l’extérieur. Fait de
thermoplastique résistant aux écarts de température et à l’humidité, le boîtier résiste
ainsi au fendillement et à la décoloration. Son couvercle peut être fixé à l’aide d’une
attache autobloquante ou d’un dispositif de blocage semblable.
Pour assurer la sécurité complète d’une maison, ajoutez le dispositif SPD4home, qui
protège les circuits d’alimentation c.a., ainsi que l’ensemble SPD4coax, qui protège les
liaisons par câble coaxial.
Données techniques
Limiteur général de surtension
SPD4tel & SPD4telkit
Protège le téléphone ou appareils électroniques
branchés à un modem contre les surtensions
Caractéristiques et avantages
Manuel d’installation - Canada
Français / French
Technical Specifications
AC SURGE PROTECTION
Catastrophic Surge Circuit Yes
Spike Capacity 200 Amps
Let Through Voltage <270 V
Overcurrent Protection Yes
Response Time <1 nanosecond
Environmentally Sealed Yes
AGENCY APPROVALS & WARRANTY
UL/cUL Listings 497A
Meets Telcordia (formallly Bellcore) GR-974-CORE
Requirements for Telecommunications Line Protectors Yes
Product Warranty 5 Years
CATALOG NUMBER
SPD4tel 2 pair protection module
SPD4telkit 2 pair protection module 1 Weatherproof Enclosure
UL Model No. - SATH2
* Voir le site www.purgethesurge.ca pour les modalités de la garantie.

8
Siemens Canada Limitée
2 Kenview Boulevard
Brampton, Ontario L6T 5E4, Canada
SPD Hotline : [phone]
www.siemens.ca
Manuel d’ installation - Canada
NE PAS INSTALLER PENDANT UN ORAGE.
Le dispositif SPD4tel peut être utilisé à
l’intérieur comme à l’extérieur, s’il est placé
dans un boîtier étanche (SPD4telkit). Veuillez
suivre les directives d’installation, à défaut
de quoi, vous vous exposez à des blessures
et/ou risquez de causer des dommages à
l’équipement non couverts par la garantie.
SPD4tel – Pour usage intérieur :
▪Le dispositif SPD4tel, qui protège deux
paires de câbles (une par module de
protection), est destiné à un usage
intérieur seulement, à moins de le
poser dans un boîtier additionnel.
▪Le fixer solidement à la surface de
montage.
▪Installer le câble de mise à la terre et,
s’il y a lieu, le bouclier, au moyen de
l’écrou central supérieur du support de
fixation, puis serrer l’écrou fermement.
▪Raccorder une paire (tête et nuque)
sous l’écrou inférieur de chaque module
de protection, la tête sur une borne, la
nuque sur l’autre.
▪Raccorder le câblage client, tête et
nuque, sous l’écrou supérieur du même
module de protection (le module est
câblé en parallèle).
▪Vérifier tout le câblage pour vous
assurer qu’il est bien raccordé et qu’il
n’y a pas de connexion lâche, de fil
endommagé ou de risque de court-
circuit.
SPD4telkit – Pour usage extérieur :
▪Fixer solidement le boîtier étanche sur
une surface plane.
▪Les conducteurs entreront et sortiront
par le
passe-câble souple situé à la base du
boîtier.
▪Suivre les directives ci-dessus pour
raccorder le SPD4tel.
▪Bloquer le couvercle du boîtier avec une
attache autobloquante ou un moyen de
fixation semblable.
▪L’ensemble SPD4telkit est un dispositif
parallèle.
Installation Instructions:
Telco Side Cable
Terminate Between
Washers
Ground Clip
Customer Side
Cable
Terminate Between
washers

12.12.11
888-333-3545
s