
806923A03
s
Test Kit, Power Stick
Dispositivo de prueba
Vis plombables pour prise de raccordement
1 / 4
3
5
4
2 x 9V
2
1
2
1
9 lb. in
[ 1.0 Nm ]
Installation Instructions / Instructivo de Instalación
For Use With Frame DG - PG
Para Usar Con Caja Base DG - PG
Use only with Siemens certified Components.
Utilizar únicamente con componentes certificados de Siemens.
A utiliser uniquement avec les composants certifiés Siemens.
Turn off and lock out all power supplying this device before
working on this device.
Replace all covers before power supplying this device is
turned on.
Couper l'alimentation de l'appareil et barrer avant de
travailler.
Remplacez touts les couverts avant que
l'approvisionnement de pouvoir soit alimenté.
Tensión peligrosa.
Puede causar la muerte o lesiones graves.
Tension dangereuse.
Danger de mort ou risque de blessures graves.
Hazardous Voltage.
Will cause death or serious injury.
Desenergice totalmente antes de instalar o darle servicio.
Reemplace todas las barreras y cubiertas antes de
energizar el interruptor.
Turn off and lock out all power supplying this device before
working on this device.
Replace all covers before power supplying this device is
turned on.
Couper l'alimentation de l'appareil et barrer avant de
travailler.
Remplacez touts les couverts avant que
l'approvisionnement de pouvoir soit alimenté.
Tensión peligrosa.
Puede causar la muerte o lesiones graves.
Tension dangereuse.
Danger de mort ou risque de blessures graves.
Hazardous Voltage.
Will cause death or serious injury.
Desenergice totalmente antes de instalar o darle servicio.
Reemplace todas las barreras y cubiertas antes de
energizar el interruptor.
3VL90008AP01
Item: EPSP18V
U.S. Cat. No. Euro Order No.
EPSP18V
3VL90008AP01
I.L. No. 806923A03
NOTE - These instructions do not purport to cover all details or variations in
equipment, or to provide for every possible contingency to be met in connection
with installation, operation or maintenance. Should further information be desired
or should particular problems arise, which are not covered sufficiently for the
purchaser’s purposes, the matter should be referred to the local Siemens sales
office. The contents of this instruction manual shall not become part of or modify
any prior or existing agreement, commitment or relationship. The sales contract
contains the entire obligation of Siemens. The warranty contained in the contract
between the parties is the sole warranty of Siemens. Any statements contained
herein do not create new warranties or modify the existing warranty.
Trademarks - Unless otherwise noted, all names identified by ® are registered
trademarks of Siemens AG or Siemens Industry, Inc. The remaining trademarks in
this publication may be trademarks whose use by third parties for their own
purposes could violate the rights of the owner.