Signature Hardware VESSEL SINK User manual

VESSEL SINK INSTALLATION
GETTING STARTED
BEFORE YOU BEGIN
We recommend consulting a professional if you are
unfamiliar with installing bathroom fixtures and plumb-
ing. Signature Hardware accepts no liability for any
damage to the floor, walls, plumbing, vanity cabinet, sink,
counter top, or personal injury during installation.
Observe all local plumbing and building codes.
Unpack and inspect the sink for damage. If any damage
is found, contact our Customer Relations team at
1-866-855-2284.
Ensure that you have gathered all the required
materials that are needed for the installation.
For the following instructions, it is assumed that the
vanity and countertop are already in place.
TOOLS AND MATERIALS:
1Vessel Sink Installation Instructions
Silicone Sealant
(100% Neutral
Cure)
Damp Cloth

VESSEL SINK INSTALLATION
Installation
3. If desired, apply a continuous bead of silicone sealant
around the perimeter of the sink base for additional
stability.
1. Carefully place your vessel sink upside down on the
counter top. Apply a generous amount of silicone
sealant to the base of the sink where it will rest on the
counter.
2. Turn the sink right-side-up and position over the
drain hole. Set the sink in place, and press firmly to
secure.
2Vessel Sink Installation Instructions
4. Remove any excess sealant with a damp cloth to
complete installation.

VESSEL SINK INSTALLATION
6. Allow the sealant to fully dry for 24 hours.
5. Proceed to the installation of the sink drain. Refer to
the drain’s installation instructions for guidance.
3Vessel Sink Installation Instructions
24 hr