Silvair DG559MB04A1A01 Product manual

July 2019
DG559MB04A1A01
Technical reference manual
Date:
01
. 0
7
. 2019
Version: 20190
7

www.dglight.eu
DG559 Technical reference manual
All of the contents are protected from copying under the provisions of copyright laws.
The copyrights belong to DG Light. Any unauthorized copying, alteration, distribution, transmission,
performance, display or other use of this material is prohibited.
[e-mail] www.dglight.eu page 1

DG559 Technical reference manual
Table of Contents
Table of Contents ......................................................................................................................2
1. Product description ..............................................................................................................3
2. Technical data......................................................................................................................4
3. Wiring diagram and description ............................................................................................5
4. Installation and precautions..................................................................................................6
5. Commissioning by SILVAIR .................................................................................................7
6. Contact ................................................................................................................................8
[e-mail] www.dglight.eu page 2

DG559 Technical reference manual
1. Product description
DG559MB04A1A01 is a wireless Bluetooth Mesh® control unit for lighting drivers with 0-10V dimming
interface resulting in an easy and smart way to provide Bluetooth Mesh® network capabilities to 0-10V
dimmable lights.
[e-mail] www.dglight.eu page 3

DG559 Technical reference manual
2. Technical data
Supply Input
Voltage range: 90÷264 VAC
Frequency: 50÷60 Hz
No Load power consumption: 580mW@220VAC 50Hz
0-10 V Output Voltage range: 0-10Vdc
Max. load current :20mA
Operating conditions
Ambient temperature, ta: -20...+50°C
Max. case temperature, tc: +70 °C
Storage temperature: -25...+70 °C
Max. relative humidity: 0...80%, non-cond.
Connectors
Wire range, solid & stranded: 0,75
-
1,5 mm
2
(14
-
22 AWG)
Mechanical dimensions
40x80x24,5 mm (40X100X24.5mm with cable ties accessories)
Protection degree
IP20
[e-mail] www.dglight.eu page 4

DG559 Technical reference manual
3. Wiring diagram and description
N
Neutral
line mains power supply connector
L
Load
line mains power supply connector
LED1 Bluetooth mesh status LED (see
Note 1
)
RESET To trigger factory reset, please place a magnet near RESET for at least 5
seconds until LED1 will start blinking as unprovisioned according to Note1
0
-
10V +
Positive 0
-
10V interface output connector
0-10V - Negative 0-10V interface output connector
Note 1: LED1 provides an indication of the device state as reported below:
[e-mail] www.dglight.eu page 5

DG559 Technical reference manual
4. Installation and precautions
 Make sure that the mains voltage is switched off when making any connections.
 Use 0,75- 1,5 mm2 solid or stranded conductor electrical wires.
 Connect wires as shown in wiring diagram paragraph and tighten the connector screw.
 Make sure to connect the input and outputs correctly.
 Mains input connector is marked with letters L and N.
 Connect 0-10V dimmable light to 0-10V DG559MB04A1A01 output connectors paying attentions to
the correct polarity.
Notes:
DG559MAB04A1A01 is a built-in class II device. Use double insulated wires or an external mounting box if
the device is not mounted inside another insulated device.
Make sure that the ambient temperature does not exceed the specified maximum value.
[e-mail] www.dglight.eu page 6

DG559 Technical reference manual
5. Commissioning by Silvair
DG559 is based on Bluetooth Mesh Silvair commissioning platform
Silvair Commissioning is a set of software tools that allows commissioning agents, contractors, installers and
facility managers to configure, control and manage commercial lighting infrastructures based on qualified
Bluetooth mesh.
Silvair Commissioning consists of two elements:
 Silvair web app, which is used off site to manage lighting installation projects, plan commissioning
along with mapping zones on a floor within a building, setting up control scenarios for zones and
managing users collaborating on the project.
 Silvair mobile app, which is used on site to commission the devices with the commissioning plan set
up earlier in Silvair web app. It has the basic features for managing a project so it can also be used
to perform any fine-tuning or commissioning small projects.
Please contact SILVAIR at [email protected]m for the Commissioning user manual
[e-mail] www.dglight.eu page 7

DG559 Technical reference manual
Contact:
[email protected]
www.dglight.eu
+39 011.9040938
Our office:
Via Giaveno, 20
10040 - Cumiana (TO)
ITALY
[e-mail] www.dglight.eu page 8