Silver Cross Doll’s Pram User manual

Doll’s Pram
IMPORTANT: KEEP THESE INSTRUCTIONS
FOR FUTURE REFERENCE

2
Fitting the wheels
1.1 Place the pram on its side on a clean
and cushioned surface and ensure
the parking device “A” is in the “off”
position.
1.2 Place the smaller wheel on the axle
nearest the apron “B”. To attach the
wheel simply pull out the metal tab “C”
and slide the wheel onto the axle “B”.
1.3 Lift the metal wheel until the tab “C”
clicks into place. The wheel should be
held firmly in position.
1.4 Repeat this process with the larger
wheel which should be fitted on the end
of the pram nearest the hood on axle “D”.
1.5 Repeat the process on the other side of
the pram and place upright.
1.1
A
1.2
1.3
C
1.4
1.5
D B

3
silvercrossbaby.com
Fitting the toy pram handle
Assembly and fitting of the handle should be
done by an adult.
NOTE: When fitting the handle, take
care to avoid damage to the paint work.
WARNING: Great care must be
taken not to mis-align screws
‘F’ and ‘G’ when attaching the
S-shaped lever ‘E’ to the body side.
Tightening the screw when mis-
aligned will damage both the screw
and the nutsert secured in the body.
2.1 Attach the two S-shaped levers ‘E’ with
the flat side against the body, using the
short screws ‘F’ and long screws ‘G’, as
shown.
2.2 Attach the gripping handle ‘H’ to the
S-shaped levers ‘E’ using a washer ‘I’
and nut ‘J’ on either side. Tighten the
nut using a suitable spanner.
E
G F
2.2
HEIJ
2.1

4
Removing the wheels for
maintenance
3.1 To remove the wheels turn the pram on
its side, ensuring that the parking device
is in the “off” position. Pull out the metal
tab ‘C’ and slide the wheel off axle.
WARNING: Always ensure when
placing the pram on its side
that the surface is clean and
cushioned to avoid damage to
the body surface.
Note: Refer to “fitting the wheels
section” for how to fit the wheels back
on to the pram.
3.1
C

5
silvercrossbaby.com
The hood and apron
CAUTION: Be sure that all parts of
the body and clothing are clear of any
moving parts.
4.1 Lift hood into semi-upright position. Fix
the hood in the fully open position by
pushing down on levers ‘K’.
WARNING: Always detach the
“storm flap” before folding
back the hood.
4.2 Attach the apron by fastening the press
studs on either side of the pram. To hold
the “storm flap” in place, loop the metal
fastener ‘M’ over the nut ‘L’ on either
side of the hood.
4.3 To operate the parking device lift the
lever ‘A’. To release the parking device,
push down lever ‘A’.
ALWAYS use the parking device
when the pram is stationary
K
4.1
4.2
M
L
4.3
A

6
Safety notes
WARNING: Not suitable for children
under three years. Small parts,
choking hazard.
WARNING: Adult assembly required.
WARNING: Keep away from fire.
Complies with applicable safety standards.
Your new toy pram is a quality Silver Cross
product. It meets current safety standards and
with correct use and maintenance should give
good service. If, however, should you have
any problems with your pram, please contact
your local Silver Cross retailer who will take
the appropriate action.
Never allow your child to climb into this toy
pram nor should it be used to carry pets.
Do not hang heavy objects from the handle.
This may cause the toy pram to tip up.
Guarantee:
All Silver Cross products are guaranteed
for a period of 12 months against faulty
workmanship, when the product is used
correctly according to the instruction manual.
Care and Maintenance
Fabric – DO NOT WASH any fabric parts
of your pram. This will damage the fabric.
Sponge gently with lukewarm soapy water.
DO NOT use chemicals or biological
detergents.
Rinse well with clean water to avoid staining.
Always allow to dry naturally, away from
sunlight.
Keep the hood fully open and the apron in
place until completely dry.
Vinyl– Sponge the lining regularly with
lukewarm soapy water. Wipe dry with a soft
cloth. DO NOT use polish.
Paintwork – Polish the paintwork with any
well known brand of liquid wax. Always follow
manufacturers instructions on the container.
Use a lint free polishing cloth to buff the
paintwork to the desired finish.
Bright metalwork – Clean regularly with
chrome polish to reduce the possibility of
corrosion and rust forming.
Wheels – The wheels should be removed
from time to time. Wipe the axles clean and
smear with a light grease before refitting the
wheels. This will help to keep your toy pram
running smoothly.
General care – Always check your pram for
signs of wear, lubricate moving parts regularly,
especially the wheel axles, brake springs
and lower parts of the chassis which tend to
collect dirt.

7
silvercrossbaby.com
Accessories Available
Navy Pram Bag, Chrome Shopping Basket,
Three Piece Bedding Set, Sun Canopy, and
Rain Shield.
All sold separately.

SXFREEWAYUK03 13
Silver Cross (UK) Ltd, Micklethorn, Broughton, Skipton, North Yorkshire, BD23 3JA
silvercrossbaby.com