5
SSM 200 A1
GB
IE
Assembly
1) Remove all packaging materials and any stickers
from the appliance.
2) Clean the appliance as described in the section
“Cleaning and Care”.
3) Place the motor unit 0on a flat surface.
4) Push the knife roller 5into the roller housing 3.
The drive shaft 4must project into the opening
of the roller housing 3.
5) Screw the end cap 8onto the roller housing 3,
until the outlet 9is pointing downwards and
the end cap 8no longer turns. In doing so,
turn the end cap 8in clockwise direction.
6) Push the assembled roller housing 3into the
motor unit 0, so that the feed tube 2is slightly
offset (see Figure B on the fold-out page). The
locking mechanisms on the roller housing 3
must reach into the slots on the motor unit 0.
Turn the roller housing 3, so that the feed tube 2
is facing upwards and the roller housing 3
snaps into place (see Figure C on the fold-out
page).
7) Place the pusher 6into the feed tube 2.
NOTE
► The pusher lid 7can be removed.
For removal:
–Turn the pusher lid 7anticlockwise until it
allows itself to be removed.
For set up:
–Place the pusher lid 7on the pusher 6,
so that both locking mechanisms on the
pusher lid 7slide through the slots on the
pusher 6and then turn the pusher lid 7
in clockwise direction so that it is firmly
held in place.
8) Insert the plug into a mains power socket.
The appliance is now ready for use.
Preparing ingredients
CAUTION! MATERIAL DAMAGE!
► Do not process fruits with stones or cores.
► Do not process whole nuts.
► Do not process ice cubes.
♦ Peel fruits such as bananas or kiwis.
♦ Remove cores, stones or stems from the fruit.
♦ Cut the fruit into small pieces so that it will easily
fi
t through the feed tube 2.
♦ Ingredients such as such as cooking chocolate
must be crushed into small pieces.
♦ Put the prepared fruit in freezer bags or plastic
tubs and place them into the freezer for approxi-
mately 24 hours (-18°C).
NOTE
► Instead of freezing fresh fruit, you can use fruit
that has already frozen from the deep-freezer.
Using the appliance
1) Take the fruits out of the freezer about 10–
20 minutes before use.
2) Place a suitable bowl under the outlet 9.
3) Remove the pusher 6from the feed tube 2.
4) Add the prepared fruits into the feed tube 2.
5) Switch on the appliance using the on/off
switch 1(position I).