SDRB 1000 B1 GB│IE│NI│CY │ 7 ■
CAUTION
► Always remove the plug 7from the power
socket before filling the appliance! There is a
risk of electric shock!
♦ Remove the water tank 1by sliding back the
release 4 of the water tank 1 until you can lift
the water tank 1 up. Grip the water tank 1
by the protruding gripping aids with your thumb
and index finger and lift it up vertically. The tem-
perature control 3stays on the appliance and
is not removed along with the water tank.
♦ Open the filler opening 2in the water tank 1.
♦ Use the measuring cup tto fill the water tank 1
with water to the "Max" marking.
♦ Close the filler opening 2in the water tank 1.
Ensure that the collar in the filler opening 2
locks into the notch on the lid. This means that
the water tank 1is properly closed.
♦ Replace the water tank 1onto the appliance.
The water tank 1must audibly click into the
release of the water tank 4.
Attaching/removing the brush
extension
CAUTION
► Never remove or attach the brush extension w
while the appliance is hot.
Risk of burns!
♦ To use the steam and brush functions, please at-
tach the brush extension w to the steam brush.
♦ To do this, push the brush extension w onto
the appliance along the guide aid until it is fully
attached. The release of the brush extension q
must click into place audibly.
♦ To use the ironing function, please remove the
brush extension wfrom the steam brush.
♦ To do this, push the release q downwards and
pull the brush extension woff the appliance.
Steam brush function
♦ Attach the brush extension wto the appliance.
It must audibly click into the release of the brush
extension q.
♦ Insert the plug 7into a properly installed and
grounded wall socket.
♦ To produce steam, set the temperature control 3
to ••• or higher. The heat-up indicator lamp 5
lights up. As soon as the selected temperature
has been reached, the heat-up indicator lamp 5
goes out.
NOTE
► To use the steam burst function, set the tem-
perature control 3to ••• or higher.
Lower temperatures are insufficient for pro-
ducing a burst of steam.
♦ You can now produce a burst of steam by press-
ing the steam burst button 8.
NOTE
► To produce the first burst of steam after heat-
ing the appliance, you may have to press the
steam burst button 8several times in a row.
The appliance is now ready for use.
CAUTION
► The steam brush can be used with any piece
of clothing. Be careful when treating heat-
sensitive textiles such as synthetics, polyamide
or artificial silk. Before treating such materials,
first process a small test patch in an invisible
spot (inside of the seam) to ensure that the hot
steam does not damage the material. Do not
apply the hot ironing sole 0to these materi-
als directly. Only use the steam burst function.
IB_368338_SDRB1000B1_LB6_GB-IE-NI-CY.indb 7 19.01.2021 15:45:39
