SimpliFire FOL-INC36 User manual

SimpliFire • Inception Folio Decorative Front • 4200-931 • Rev B • 8/23
1
Inception Folio Decorative Front
Model: FOL-INC36
- Installation Instructions -
Figure 3 Install Shoulder Bolts
1. Locate side panels (B,C) in the component box shipped
with the appliance.
2. Remove all materials from the front packaging.
3. To position the side panels lift up slightly on the Display
Bracket shelf in order to place the bottom ange of the
side panel under the ember tray for support.
4. Install the side panels using shoulder bolts (A) into the
four threaded inserts located in the appliance surround.
See Figure 3.
Leave this manual with party responsible for use
and operation.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
CAUTION! Do not install damaged components.
For Model(s):
SF-INC36
Tools Needed
• 1/8” Hex Key
Figure 2 Components Overview
Installation:
Note: To avoid potential damage to hearth pad or ooring,
protect area in front of appliance by laying down card-
board or blanket.
Introduction
These are instructions for the Inception Folio decorative
front. This decorative front is compatible with the Incep-
tion appliance.
Figure 1 Folio Decorative Front
SHOULDER BOLTS x 4
(1/4"x3/8" shoulder, 10-24 thread)
LEFT AND RIGHT SIDE PANELS
NOTE: Side panels located in appliance
component box.
(A)
(B) (C)
SHOULDER
BOLTS (A)
(B & C)
SIDE PANELS

SimpliFire • Inception Folio Decorative Front • 4200-931 • Rev B • 8/23
2
Cleaning Instructions for Decorative Fronts
Use a microber cloth and Windex® Original Glass
Cleaner or 03M003 Stove Bright® Glass Cleaner to
clean the decorative front immediately after installation
to remove acids deposited by the installer or technician.
Spray the cleaner onto the microber cloth and carefully
wipe the entire surface. The decorative front should
be cleaned in this manner annually by the homeowner
to remove ngerprints or other contaminants. Once
oxidation of the paint pigment has occurred, cleaning will
not restore the original color.
SimpliFire, a brand of Hearth & Home Technologies
7571 215th Street West, Lakeville, MN 55044
www.hearthnhome.com
Please contact your SimpliFire dealer
For the location of your nearest SimpliFire dealer,
please visit www.hearthnhome.com.
Figure 4 Connect on Device Controls
TOP SLOTS
BOTTOM SLOTS
CONNECT
WIRE HARNESS
Replacement Parts
• Side Panels SRV4200-106
• Vanity Panel Assembly SRV4200-034
• Door Buttons Jumper SRV4200-183
4. Connect the wire harness for the controls at the lower
right of the front to the corresponding connector from
the appliance. See Figure 4.
NOTE: Before installing decorative front, make sure the
appliance junction box master switch is ipped to the
ON position.
5. Align the bottom slots on the decorative front with the
bottom shoulder bolts and set the front onto the bottom
shoulder bolts. Tilt the decorative front towards the ap-
pliance until it contacts the top shoulder bolts. Once the
decorative front contacts the top shoulder bolts, lift up
slightly and push decorative front toward appliance until
slots and bolts are engaged. Release the decorative
front. The decorative front now hangs on the top two
shoulder bolts and is properly secured.
6. Ensure the decorative front is properly attached and
securely positioned on the appliance.