Siqura XCU Fusion User manual

.. or assign IP address without DHCP
XCU Fusion
316L stainless-steel dual imager camera
Quick Start Guide
© Siqura B.V. 2018
Version
0.4 (181904-04)
XCU
Fusion QSG (MW10)
Assign IP address with DHCP…
Unpack
Mount
Install Device Manager
Connect and point
Note 1: Subject to modification. Actual product and accessories may differ in appearance.
Find additional manuals, the datasheet,
the EU Declaration of Conformity, and the latest
firmware for this product at:
siqura.com/downloads/software
siqura.com
•1x Camera unit
•1x Quick Start Guide
CAUTION:
MAKE SURE THAT THE POWER SUPPLY VOLTAGE MATCHES THE
VOLTAGE RATING OF
THE XCU FUSION. CHECK THE PRODUCT LABEL TO
DETERMINE THE VOLTAGE REQUIRED FOR PROPER OPERATION.
DO
NOT CONNECT A 24 VAC MODEL TO A 115 VAC OR 230 VAC POWER SUPPLY!
10.x.y.0 Cat 5
Video Management System
NTP
Wall mounted XCU Fusion XCU Fusion ceiling mounted on XCUCM01
XCU Fusion ceiling mounted on XCUCM02 XCU Fusion wall/pole mounted on XCUCM02
Connect to network Connect to power (see warning below)
Pinning power connector
Note 2: For detailed mounting instructions, download the installation manual.
Note 3: The silica gel packet inside the camera must be replaced if the camera has been
opened.
Note 4: On the Siqura website, choose SDM2 2.4.0 installer or higher.

Change image settings View video stream in video player
Change network settings
Upgrade firmware
Create Admin account
View live video via browser
rtsp://10.0.231.156/VideoInput/1/h264/1
video input number
1 = optical input
2 = thermal input
camera IP address
media
type
video encoder number
1
2
3
4
IMPORTANT
:MAKE SURE YOU CREATE AN ADMIN ACCOUNT WHEN YOU OPEN
THE WEB INTERFACE FOR THE FIRST TIME. TO KEEP THE ACCOUNT SAFE, SET A
STRONG, COMPLEX PASSWORD. THIS HELPS TO PREVENT UNAUTHORISED
ACCESS.
Set a strong password!
1
2
1
2
IMPORTANT
:FOR BEST PERFORMANCE AND NETWORK SECURITY, MAKE SURE
TO DOWNLOAD THE LATEST FIRMWARE
VERSION FROM SIQURA.COM.
THEN, UPGRADE THE FIRMWARE IN THE DEVICE MANAGER (SEE BELOW).