Sister Bay Hudson MHUD-DT28 User manual

SOCKET HEAD WRENCH
( not included )
Do not use
any hand drill
on this product
PHILLIPS SCREWDRIVER
( not included )
WRENCH
( not included )
1- After laying out all components, locate Leg Assembly 1 ( H ) and Leg Assembly 2 ( I ) and cross them over each
other as shown in the graphic below. Secure them in place using a Support Bracket ( L ) and (4) 1-1/2 Screws ( D ).
Tighten the screw until the top is flush with the top of the Support Bracket.
Carefully turn the legs over and attach the other Support Bracket ( L ). Tighten the 4 screws ( D ) until they are flush
with the top of the Support Bracket.
Figure 1
Hardware and Parts
(8)
2.75
B
(9)
C
(12)
(8)
A
(8)
B1
4.00
(4)
E
ALLEN WRENCH
( included )
1.50
D
H
L
( Leg Assembly 1)
( Support Bracket )
D
I
( Leg Assembly 2)
Assembly Instructions
Item No: MHUD-DT28B
Hudson 28" Bar Table
Item No: MHUD-DT28
Hudson 28" Dining Table
Item No: MHUD-DT30B
Hudson 30" Bar Table
Item No: MHUD-DT30
Hudson 30" Dining Table
H
( Leg Assembly 1)
K
L
( Support
Bracket )
I
G
( Top )
J
( Foot 1 ) ( Foot 2 )
( Leg Assembly 2 )

3 - Finalize the assembly of table by attaching the Feet. With the table still on it's Top, place Foot 1 (J) and Foot 2 (K)
on the of the Legs. Putting a Lock Washer (B1) and Washer (B) on each Lag Screw (E), push the screw into each
hole as shown below. Tighten the Lag Screw into the predrilled hole with a Socket Wrench. Next, secure the cross
of the Feet with a single Screw (D) in the center, driving the screw until flush with a screwdriver.
Figure 3
Figure 2
C
B1
B
GH
A
( Detail 1 )
E
B
D
2 - Place and align the top of the legs with the aluminum support holes in
the Table Top ( G ). The top of the legs have slots cut in them for ease
of assembly. Align and insert a bolt (A) into all 8 holes, insert washers
(B)(B1) and hex nut (C) from the opposite side. Once all bolts are in
place the next step is to tighten the bolts (A) and hex nuts (C). Use the
Allen Wrench an Adjustable Wrench to tighten all 8 connections ,
assembly shown in detail below.
CARE AND MAINTENANCE
To clean your product, use mild soap and water. For heavy soil build-ups use any non-abrasive household cleaners
or ask your Sales Representative about Sister Bay Furniture Cleaner.
Please contact our Customer Service Department for assembly assistance, questions or replacement parts at 1-866-947-7632
or email [email protected]. Our Customer Service Department is available Monday - Friday from 8:30 a.m. to 4:30 p.m. EST