Sister Bay Hyannis Adirondack Rocker Quick start guide

( Detail 1 )
WRENCH
( not included )
You will also need a phillips-head screwdriver
( not included )
A
B
C1
(6)
(12)
Do not use
any hand drill
on this product
1.50
D1
ALLEN WRENCH
( included )
(6)
3.50
(6)
C
( 2 )
1.00
Hardware and Parts
Item No: MHYA-A-R
Hyannis Adirondack Rocker
Assembly Instructions
( Seat Back )
I
( Right Arm Assembly )
F
H
( Right Leg Assembly )
J
( Left Leg Assembly )
K
( Seat Bottom )
( Left Arm
Assembly )
G
Assembly Instructions
1 - Attach part ( K ) , Left Leg Assembly , to part ( G ) Left
Arm Assembly as shown in figure 1. First place arm on
clean flat surface, align the holes on left leg assembly
with the holes on the under arm brace using ( 2 ) of
screws ( C ) tighten using a phillips-head screwdriver.
Second using ( 1 ) of screw ( C1 ) insert into ( Decorative
piece ) screw into the arm using a phillips-head
screwdriver as shown in figure 1. Follow the same
instructions for Right Leg and arm assembly.
2 - Attach part ( J ) ( K ) , Left Arm & Leg Assembly , to
Assembly from figure 2 as shown in figure 2. Align and
insert 3 of bolt ( A ) into holes and insert washers (D),
(D1) and hex nuts (E) from the other side, see detail 1
tighten bolts using an allen wrench and also an
adjustable wrench. Follow the same instruction for
Right Arm & Leg Assembly.
Figure 1
( Left Arm & Leg Assembly )
G
( Left Arm Assembly )
G
( Left Leg Assembly )
K
K
C
C1
( Decorative
Piece)
1st
2nd
Figure 2
A
E
D
D1
E(6)
D
( Base Rocker )
L
2.75
(6)

3 - Attach the assembly from Figure 2 and part ( I ) , Seat Back, as shown in Figure 3 by pushing the lower end
of the Seat Back forward against seat slats using ( 4 ) of screw ( C ) and tighten screws using a phillips-head
screwdriver as shown in detail 2 and detail 3.
4 - To complete the assembly use ( 4 ) of screw ( C ) as shown in detail 4 and detail 5 in figure 4 and
tighten screws using a phillips-head screw driver.
( Seat Back )
I
push forward against seat slats
C
C
( Detail 3 )
C
C
( Detail 4 ) ( Detail 5 )
Figure 3
Figure 4
( Detail 2 )
Figure 5
5- Attach parts ( L ), Base Rocker to assembly from Figure 4 using 6 of lag screws ( B ) as shown in details 6 and
7, tighten screws using an allen wrench . Follow the same instruction for the left and right base rockers.
( Detail 7 )
( Detail 6 )
B
B
CARE AND MAINTENANCE
To clean your product, use mild soap and water. For heavy soil build-ups use any non-abrasive household cleaners
or ask your Sales Representative about Sister Bay Furniture Cleaner.
Please contact our Customer Service Department for assembly assistance, questions or replacement parts at 1-866-947-7632
or email [email protected]. Our Customer Service Department is available Monday - Friday from 8:30 a.m. to 4:30 p.m. EST