Snom 300 User manual

Snom 300 Quick Reference
1 | Snom 300 Quick Reference
Message waiting
indicator
Handset
Cancel key
Navigation key
Enter key
Address book
Mute / DND
(when call is not
taking place)
Line keys / place
active call on hold
Keypad

2 | Snom 300 Quick Reference
Making a Call
There are three ways to place a call:
• Completely handsfree - dial the number and press
• Handsfree dialling - dial the number and pick up
the handset.
• Handset dialling - pick up, dial the number
and press
In handsfree mode, the handset may be picked up at any time.
Ending a Call
To end a call, do one of the following:
• If you are using the handset, hang up the receiver.
• If you are using the speakerphone, press
the button.
• If you are using a headset, press the button.
Making a Blind Transfer
1. Press Transfer, dial the destination number,
and press . You are no-longer part of the call.
Making a Consult Transfer
1. Place the received call on hold by pressing the line
button for that call.
2. Dial the destination number, and press OK.
3. Speak with the callee when answered and then
hanging up the handset will automatically transfer
the call.
Note: Replacing the handset will drop all active calls,
therefore if a third calls is also active at this time, you need
to choose the line to transfer; Press Transfer use left/right
arrows to display line to transfer, then press
Answering a Call
• Handsfree – press
• Handset - pick up the handset.
• Headset - if the phone is configured for a headset,
press
Answering Multiple Calls
1. Place the current call on hold by pressing the current
line-button (solidly lit L1 or L2 button).
2. The phone will start ringing. Press to answer
this call.
3. Switch between calls by pressing the line button of the
caller you wish to speak to. If there are three or more
calls, put the current call on hold and use the left/right
buttons on the silver keypad to select the desired line,
then press
Press to hang-up the current call rather than replacing
the handset, or you may inadvertently cause a call transfer.
Accessing Messages
If voicemail is waiting (Message light flashes), press
without dialling a number to connect to the voicemail system.
Alternatively dial the short code that has been configured on
your system.