National Barrington User manual

Assembly Instructions
Barrington®
Attaching Bases to
Conference Tables
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent. If you
have any questions concerning these instructions, please call National Customer Service.
CCAASSEEGGOOOODDSS
11
Figure A
Telephone [phone]
Fax [phone]
www.nationalonline.com
Part #1847145
Printed in U.S.A
© 2005 Kimball International, Inc.
Place top(s) upside down on a smooth,
solid surface. Take car to not mar the
worksurfaces. On two-piece tables, align
the three (3) leveling devices and tighten
bolts.
22On 14’ and 16’ tables, the mounting
pads are pre-attached (Figure A). On
10’ and 12’ tables, the center mounting
pads must be installed. Place mounting
pads as shown in (Figure B). The side
of the panel base with the two (2)
T-nuts should be placed against top
panel and the T-nuts positioned toward
outside edge of top. Use twelve (12)
washers and bolts to attach the center
mounting pads.
Recommended Tools
• Screwdriver
Figure B
NOTE: 14’ and 16’ tables use four (4) panel bases.
10’ and 12’ tables use three (3) panel bases.
8’ tables use two (2) panel bases.
Package Contents Qty.
33Remove plywood pads from the bottom
of each pedestal.
44On 14’ and 16’ tables, place panel bases
in positions shown in (Figure C). On 10’
and 12’ tables, the panel bases on each
end are attached with six (6) washers
and bolts. The center panel base is
attached with four (4) washers and
bolts. Install the adjustable glides on
each panel base (Figure D).
Figure C Figure D
Mounting Pads
Mounting Pads must
be installed on 10’
and 12’ tables
14’ and 16’ Tables 10’ and 12’ Tables

Assembly Instructions
Barrington®
Attaching Bases to
Conference Tables
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent. If you
have any questions concerning these instructions, please call National Customer Service.
CCAASSEEGGOOOODDSS
55On 8’ 14’, and 16’ tables, attach each
panel base with six (6) provided wash-
ers and bolts. On 10’ and 12’ tables, the
panel bases on each end are attached
with six(6) washers and bolts. The cen-
ter panel base is attached with four (4)
washers and bolts. Install the
adjustable glides on each panel base
(Figure E).
66Carefully turn assembled table upright.
Figure D
Bolt (4 per base)
Washer (4 per base)
Center Mounting Panel
Mounting Panel
Adjustable Glide
Panel Base
Bolt (6 per base)
Washer (6 per base)