
INSTALLATION
03
04
1. Prepare lamp, accessories, and tools.
2. Use the Allen wrench to loosen the bracket
and adjust to the appropriate angle then
screw tightly.
3. Use the Allen wrench to loosen the
light module then pull it out and adjust to
appropriate lighting angle.
4.Mount the lamp onto any wall surface or
lamp post.
Press the power button then program the
operating mode. Charge for 6 hours to get 3-4
nights of light.
OPERATING
MODES
SENSOR MODE A
Automatically turns on to full brightness
(1,080LM) when motion is detected in the
range ≤26.2ft and then dims down to 3%
brightness after 20 seconds of no motion.
SENSOR MODE B
Automatically turns on to full brightness
(1,080LM) when motion is detected in the range
≤26.2ft and then turns off completely after 30
seconds of no motion.
CONSTANT MODE
Automatically turns on at dusk and remains at a
constant 20% brightness.
Power Button
180°180°
180°180°